User manual AEG-ELECTROLUX EHS6625P

[. . . ] Ê Ceramic glass h Glaskeramisk-koge åñáìéêÞ ìáãåéñéêÞ o z b one åóôß á Installation and Operating Instructions Monterings- og brugsanvisning Ïäçãßåò óõíáñìïëüãçóçò êáé ÷ñÞóçò EHS 6625 P 822 924 233-A-110603-01 g k r Dear customer, Please read these operating instructions carefully. Pay particular attention to the section "Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. The following symbols are used in the text: 1 Safety instructions 3 Information and practical tips 2 Environmental information Warning: Information concerning your personal safety. [. . . ] After a few seconds the timer will start automatically and will show how much time remains before it will switch off. In addition, the "Timer active" display for the relevant cooking zone will light up. At the end of the set cooking time, the cooking zone will switch off automatically and an acoustic signal will sound. Touch the TIMER W sensor field to switch off the signal and control indicator. 3 To set the timer more quickly, until the required leave your finger on the + or - sensor field time is reached. If the - sensor field is operated first, the time setting will begin at 99 minutes; if the + sensor field is operated first, the time setting will begin at 1 minute. 14 Displaying the remaining cooking time If you select a cooking zone which is in timer mode, the cooking time still remaining appears in the timer display window. Using the timer to measure short periods of time ("Minute Minder"). 1 Important!the Timer!the cooking zones should None of be set with 1. Touch the "On/Off" sensor field for around two seconds. Touch the TIMER W sensor field to activate the Timer function. Using the + or - sensor fields, set the desired length of time (for example, 20 minutes). The Timer begins to run after a few seconds, and indicates the time remaining. When the set time has elapsed, an audible signal is sounded. Touch the TIMER W sensor field, to switch off the signal. Ending the timer function prematurely There are two ways of switching off the timer early: Switching off the cooking zone and timer simultaneously 1. Select the desired cooking zone using the cooking zone buttons. Touch the + and - buttons simultaneously: The cooking zone and timer will switch off. Switching off the timer - leaving the cooking zone active 1. Select the desired cooking zone using the cooking zone buttons. Touch the "Timer" button again. Touch the + and - buttons simultaneously: ­ Only the timer will switch off. ­ The cooking zone will stay on. 15 Uses, Tables and Tips Pans The better the pan, the better the results. · You can recognise good pans by their bases. The base should be as thick and flat as possible. · Pay particular attention when buying new pans to the diameter of the base. Manufacturers often give only the diameter of the upper rim. [. . . ] The two ends of the tape should join in the middle of one side. After trimming the tape (allow it to overlap by 2-3 mm), press the two ends together. 23 Electrical Connection Before connecting, check that the nominal voltage of the appliance, that is the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob. The appliance also works perfectly on older networks with AC220V~. [. . . ]