User manual AEG-ELECTROLUX EHS6631P15A

[. . . ] Only let bigger children work on the appliance under supervision. General safety The appliance may only be installed and connected by trained, registered service engineers. Built-in appliances may only be used after they have built in to suitable built-in units and work surfaces that meet standards. In the event of faults with the appliance or damage to the glass ceramic (cracks, scratches or splits), the appliance must be switched off and disconnected from the electrical supply, to prevent the possibility of an electric shock. Repairs to the appliance must only be carried out by trained registered service engineers. [. . . ] Control panel Switch off Switch on Touch Touch for 1 second for 1 second Pilot light goes out lights up Using the child safety device The child safety device prevents unintentional use of the appliance. The child safety device can only be activated immediately after the appliance has been switched on. Switching on the child safety device Step 1. 2. Control panel Switch on appliance. (Do not set a heat setting. ) Touch for 5 seconds / Display (if hot) is displayed. Appliance switches off. To override or switch the child safety device off sucessfully, the steps must be performed immediately one after the other. No other sensor fields must be touched between the steps described. operating the appliance electrolux 11 Overriding the child safety device The child safety device can be switched off in this way for a single cooking session; it remains activated afterwards. 2. Control panel Switch appliance on / Display (if hot) Touch the two of the front cookor ing zones at the same time Decimal points flash Until the appliance is next switched off, it can used as normal. Switching off the child safety device Step 1. 2. Control panel Switch appliance on Touch for 5 seconds / Display (if hot) or Decimal points flash Appliance switches off. 12 electrolux operating the appliance Safety cut-out Cooking surface If after switching on the appliance a heat setting is not set for a cooking zone within approx. 10 seconds, the appliance automatically switches itself off. If one or more sensor fields are touched for longer than approx. 10 seconds, the cooking surface is automatically switched off. Remove residues by sliding the blade over the surface. Wipe the appliance with a damp cloth and a little washing up liquid. Rub the appliance dry using a clean cloth. Remove Type of dirt sugar, food containing sugar plastics, tin foil limescale and water rings fat splashes shiny metallic discolouration immediately yes yes ------- when the appliance has cooled down ----yes yes yes using a scraper* cleaner for glass ceramic or stainless steel* *Scrapers and cleaners for glass ceramic and stainless steel can be purchased in specialist shops Remove stubborn residues with a cleaner for glass ceramic or stainless steel. Scratches or dark stains on the glass ceramic that cannot be removed do not however affect the functioning of the appliance. 18 electrolux what to do if . . . What to do if . . . Problem The cooking zones are not functioning. Possible cause No cooking zone selected Remedy Select cooking zone within 10 seconds of switching on (Decimal point lights up) Switch on the appliance again. Select cooking zone within 10 seconds of switching on The cooking zones cannot be More than 10 seconds have selected / Appliance does not passed since the appliance react to the control panel input was switched on The child safety device is acti- Deactivate the child safety devated vice (See section "Child safety device") The sensor fields are partly covered by a damp cloth or with liquid Safety cut-out has been triggered The residual heat indicator is not displaying anything Remove the cloth or the liquid Switch on the appliance again The cooking zone was only on If the cooking zone is supfor a short time and is therefore posed to be hot, call the Cusnot hot tomer Service Department. Several sensor fields were touched at the same time Safety cut-out due to overheating Appliance is incorrectly connected The overvoltage protector has been activated (for an incorrect connection see above Er25 or for overheating of the electronic components see Only touch one sensor field Let the appliance cool down. Disconnect the appliance from the electrical supply and have it connected properly Separate the appliance from the mains for a few minutes (remove the mains fuse). Let the appliance cool down. Er03 Er21 Er25 is displayed is displayed is displayed (only for 10 seconds) Er40 is displayed Er21) what to do if . . . electrolux 19 In the event of any other fault codes that arise, disconnect the appliance from the electrical supply for a few seconds. (Take out the fuse from the house's wiring system. ) If the fault is displayed again, please call the Customer Care Department and inform them of the fault code. If you are unable to remedy the problem by following the above suggestions, please contact your dealer or the Customer Care Department. Warning! [. . . ] The appliance is installed in accordance with all relevant regulations in force within your new country of residence. The provisions of this European Guarantee do not affect any of the rights granted to you by law. guarantee/customer service electrolux 23 24 electrolux service Service In the event of technical faults, please first check whether you can remedy the problem yourself with the help of the operating instructions (section "What to do if. . . "). If you were not able to remedy the problem yourself, please contact the Customer Care Department or one of our service partners. In order to be able to assist you quickly, we require the following information: Model description Product number (PNC) Serial number (S No. ) (for numbers see rating plate) Type of fault Any error messages displayed by the appliance three digit letter-number combination for glass ceramic So that you have the necessary reference numbers from your appliance at hand, we recommend that you write them in here: Model description: PNC: S No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]