User manual AEG-ELECTROLUX EHS6650P

[. . . ] Ceram Placa em ÊåñáìéêÞ i ì c v á i glass h dro cer ãåéñéêÞ o â b mi åó c ô o ßá Installation and Operating g Instructions Montagem e indicações de m utilização zação Ïäçãßåò óõíáñìïëüãçóçò êáé ÷ñÞóçò EHS 6650 P 319 639 500-NO-100502-01 g p r Dear customer, Please read these operating instructions carefully. Pay particular attention to the section "Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. The following symbols are used in the text: 1 Safety instructions 3 Information and practical tips 2 Environmental information Warning: Information concerning your personal safety. [. . . ] This function is also suitable as a child safety feature. Touch the , , lock" sensor field until the control indicator comes on. To release the lock touch the , , lock" sensor field again continuously until the control indicator goes out. 3 Child safety feature!If the hob is completely switched off using the "On/Off" sensor field while the lock is on, then the lock will still be active when the hob is switched on again. To reactivate the cooking zones, the locking function must be cancelled as described above. Timer A cooking duration can be set with the integrated timer for all cooking zones. When the end of the cooking duration is reached, the cooking zone switches itself off automatically. Using the cooking zone sensor field, select the required cooking zone and set the required heat setting. Touch the TIMER W sensor field to activate the timer function for this cooking zone. 00 will appear in the display. 3 To set the timer more quickly, until the required leave your finger on the + or - sensor field time is reached. Using the + or - sensor fields set or adjust the required period of time until the zone is to switch off automatically (eg. After a few seconds the timer will start automatically and will show how much time remains before it will switch off. In addition, the "Timer active" display for the relevant cooking zone will light up, e. g. the top left control indicator corresponds to the rear left cooking zone. At the end of the set cooking time, the cooking zone will switch off automatically and an acoustic signal will sound. Touch the TIMER W sensor field to switch off the signal and control indicator. If the - sensor field is operated first, the time setting will begin at 99 minutes; if the + sensor field is operated first, the time setting will begin at 1 minute. Displaying the remaining cooking time If you select a cooking zone which is in timer mode, the cooking time still remaining appears in the timer display window. Using the timer to measure short periods of time ("Minute Minder"). the Timer!the cooking zones should None of be set with 1. Touch the "On/Off" sensor field for around two seconds. Touch the TIMER W sensor field to activate the Timer function. Using the + or - sensor fields, set the desired length of time (for example, 20 minutes). The Timer begins to run after a few seconds, and indicates the time remaining. When the set time has elapsed, an audible signal is sounded. Touch the TIMER W sensor field, to switch off the signal. Ending the timer function prematurely There are two ways of switching off the timer early: Switching off the cooking zone and timer simultaneously 1. [. . . ] · The hob must be pressed out from below when removed. · Clean the work surface in the area of the cut-out. · Four sealing tapes which are self-adhesive on one side are supplied with the appliance. Stick these on underneath the cooking surface along the outer edge of the ceramic glass hob top. [. . . ]