User manual AEG-ELECTROLUX EHT332X

[. . . ] 3 Faults . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Operating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Ignition . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Maintenance And Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Help to avoid accidents; if the unit should ever be discarded, render it useless by removing the cable, or by cutting the cable as close to the unit as possible. For safety's sake, turn pots and pans so that handles do not protrude, thus inviting accidents. Never place plastic or paper, etc. , on the unit. If the unit should be switched on by accident, the paper could burn, plastic melt, etc. Burner 1 Radio-noise reduction This unit observes the current EEC-directive on radio noise reduction. This gas appliance is -approved and marked in accordance with the gas appliance Directive (90/396/CEE), the low voltage directive (73/23/CEE) and the EMC directive (89/336/CEE incl. the agreed directive changes. Areas if use The hob is only intended for normal household use. It is important that you follow the advice given in these instructions in order to avoid any risk of damage to persons and objects. Used for any other purpose invalidates the guarantee as well as product liability. 14 3 Product liability Our liability is limited to that which is stipulated by law, and covers only damage to persons and property, which results from defects in materials and workmanship of the unit itself. This liability extends for a period of 10 years from the date of purchase as a factory-new unit. Distribution damages Any damages due to transportation by us or by our representative must be reported to the dealer not later than one week after receipt of the unit. Gas installation In accordance with local requirements for domestic gas cooking appliances. Gas installation must only be carried out by an authorised person. For gas types see technical data. Check If you make a note of the model, product and serial numbers on receipt you will always have this information to hand (See frontpage). These numbers will be needed for any service visits. The model number plate is situated on the bottom of the hob. Gas connection The gas intake is situated at the lower rear of the appliance. The intake has a ½" conical pipe thread (see fig 1) If the appliance is to be connected to a gas cylinder, conversion with the optional modification kit will be necessary. Reservations Our liability does not apply in the event that the damage in question is due to any of the following conditions: The unit has not been installed in accordance with the instructions set forth in this pamphlet. That the damage is caused by transport at a later date, for instance during removal or resale. That the damage is caused by any form of use contrary to common sense. Pressure test Size of pots and pans Medium-sized burner, recommended size 130-210 mm. Large burner, recommended size 180 280 mm. The unit should be pressure-tested at Max. 150 mbar. Positioning It is advisable to place the unit near an out-of-the-way, or closed, corner, with space on either side on which to rest hot cooking utensils. [. . . ] flame Burner 2 Bruner 1 12 Guide knob for grid 10 7 Ignition Burner cover/burner ring Together with the burner ring the burner cover forms a space where the final mixture of gas and air takes place in order to make the gas burn correctly. Please note: It is consequently very important that the individual burner cover/ring is placed correctly on the burner. The burner ring has been provided with holes for the ignition electrode, and the thermo sensor. If the burner cover/ring are wrongly placed the burner will operate incorrectly, and the burners may be damaged within at short space of time. [. . . ]