User manual AEG-ELECTROLUX EHT75X

[. . . ] The cooking zones heat up quickly when they are turned on. Turn them on only when you have placed a saucepan onto the cooking area. The residual heat indicator integrated in the electronics tells you whether a cooking zone is switched on or still hot. If you use a socket close to the hob, take care that the cable of the appliance does not touch the hot surface of the hob. [. . . ] Disconnect the appliance from the mains and inform the service department. A defective hob surface allows overboiling food to penetrate and the contact with live parts. Electrolux declines any liability should the appliance be used improperly and the safety measures not be observed. Please note the maintenance and cleaning instructions carefully. Using other hobs than those of Electrolux-Brand excludes any liability. Keep these operating and assembling instructions! 34 Before the first use Clean your ceramic hob carefully before its first use. Afterwards clean it regularly when it is just warm or cold. Avoid continued burning of food or dirt until it is solified. Ceramic hobs are treated and cleaned the same way as glass. Never use aggressive detergents or sponges with abrasive surface. When you use the ceramic hob for the first time it can temporarely emit an odeur caused by a vaporation of water in the isolation. Description of the hob EHC 010 X 1. Cooking zone Ø 180 mm, 1800 W 2200 W 1500 W 1200 W 2x 120 W 1 2 6 3 4 6 5 5 Cooking zone Ø 120/210 mm, (double-circuit zone) Cooking zone Ø Cooking zone Ø Warmhalteplatten Residual heat indicator 160 mm, 140 mm, 35 Cooking zones The cooking zones are indicated by markings on the ceramic top. The ceramic hob surface is resistant to extreme temperatures. by the fall of a salt shaker, can cause fissures and cracks. The maintenance remains the same for glass and ceramic hobs. Never use aggressive detergents or scouring powder and sponges with abrasive surfaces. Caution: As soon as any crack in the heating surface becomes visible, disconnect the appliance immediately from the supply. 37 Maintenance Ceramic hobs are treated and cleaned the same way as glass. Never use aggressive detergents or sponges with abrasive surface. Cleaning after each use Slight, not burnt soiling has to be wiped off with a damp cloth without using detergents. The use of detergents may lead to disco-louring. These heavy stains can not be wiped off easily by the first attempt and sometimes not even with a special detergent. Burnt soiling has to be removed with a scraper. Afterwards wipe off the ceramic hob with a damp cloth. Stain removal Light metallic stains (aluminium remains) can be removed from the cooled down cooking zone with a special detergent. Calcareous deposits (caused by overboiling water) can be removed with vinegar or a special detergent. [. . . ] Only install components which are in perfect condition!Do not let any sharpedged or pointed tools (screw drivers etc. ) be placed or fall onto the glass top! - Cut out worktop to prescribed measurements or tem- , , , , 504 ±1 (60 R3 984 . 50 min plates (saw exactly along the scribing). - Check seal for perfect fit and overall cover. Lower the ceramic hob into place and align orrectly. Fastening - Place the whole ceramic-hob into the cut-out. [. . . ]