User manual AEG-ELECTROLUX EHT7780K

[. . . ] English For your safety This new appliance is easy to use, however, make sure to read this handbook before installing and using it for the first time. In this way you can obtain best use, avoid incorrect operations, use the appliance in complete safety and respect the environment. Installation · Appliance installation and connection to the power supply must only be carried out by QUALIFIED PERSONNEL. Before carrying out any operation, make sure the appliance is DISCONNECTED from the power supply. Make sure air can circulate freely around the appliance. [. . . ] Do not use the following products: - household detergents or bleaches; - soapy scouring pads not suitable for non-stick recipients; - steel wool; - bath or sink stain removers. If the glass top is very dirty, use specific products available on the market. If you note breakage or cracks on the glass top, immediately disconnect the appliance, contact a Technical Assistance Centre and do not use the appliance until it is repaired. FO 2265 Fig. 3 23 Periodical maintenance Have the state and efficiency of the gas pipe and the pressure regulator (if present) periodically checked. If any anomalies are detected, have the faulty part replaced (and not repaired). To guarantee correct operation and safety, periodically grease the gas adjustment cocks. · Periodical lubrication of the cocks must only be carried out by QUALIFIED PERSONNEL; contact only qualified personnel in case of anomalies in appliance operation. Assistance and spare parts Before leaving the factory, the appliances are inspected and prepared by specialised personnel, in order to ensure best operating results. Any subsequent repairs or preparation becoming necessary must be carried out with maximum care and attention. Therefore it is advisable to always see your local dealer or the nearest Assistance Centre, specifying the type of problem, the appliance model (Mod. ), product number (Prod. This information is given on the plate located on the back cover, under the warranty terms. Original spare parts, certified by the product manufacturer, and identified by this mark, are only available at our Technical Assistance Centres and Authorised Spare Parts Shops. Warranty terms Your new appliance is covered by a warranty. The warranty terms are given in full in the documents placed inside the appliance. Carefully keep, together with the warranty documents, the receipt or the waybill, that serve to document the purchase of your appliance and the date of purchase. In case of Assistance Service intervention, show these documents to the personnel. If you do not follow this procedure, the Assistance Service will have to charge you for any repairs. 24 Technical specifications Gas burner power Triple crown burner Semirapid burner (medium) Auxiliary burner (small) Appliance class Category 3. 8 kW 1. 9 kW 1. 0 kW 3 II2H3+ Power supply 230 V 50 Hz Dimensions of opening for fitting Width Depth 560 mm. 480 mm. Appliance setting Natural gas G20 / 20 mbar Gas inlet connection G 1/2" Instructions for the installer IMPORTANT: This appliance can only be installed and used in permanently ventilated places. Appliance installation and connection to the power supply must only be carried out by QUALIFIED PERSONNEL. Before carrying out any operation, make sure the appliance is DISCONNECTED from the power supply. The Manufacturer declines any liability for possible damage due to installation not complying with the current standards or failure to respect the accident-prevention regulations. Place of installation For correct operation of the gas appliance, the air necessary for gas combustion must be able to flow naturally in the room. (The installer must comply with the current standards). The air must flow into the room through openings made in the external walls . These openings must have a free open section of at least 100 cm2 . [. . . ] · In any case, the result must be a small and even flame on all the burner crown. Lastly, check that the burner does not go off when quickly turning the cock from max. The above adjustment operations can be easily performed, whatever the positioning or fixing of the cooktop to the cabinet. Fig. flame adjustment By-pass diameters Burner Ø Cock by-pass in hundredths 28 32 56 Auxiliary Semirapid Triple crown TYPE OF GAS TYPE OF BURNER NOZZLE MARKING 1/100 mm NOMINAL REDUCED HEATING HEATING CAPACITY kW FLOWRATE CAPACITY kW 3. 8 1. 9 1. 0 3. 8 1. 9 1. 0 1. 20 0. 45 0. 33 1. 20 0. 45 0. 33 NOMINAL PRESSURE 3 m /h 0. 362 0. 181 0. 095 g/h 273 137 72 NOMINAL mbar NATURAL GAS (Methane) Triple crown Semirapid (medium) Auxiliary (small) 146 96 70 98 71 50 20 LIQUIFIED Triple crown GAS Semirapid (medium) (Butane/ Auxiliary (small) Propane) 28-30/37 28 Building In SR SR SR TC A 51 0 68 0 Dimensions in mm A = Auxiliary burner SR = Semirapid burner TC = Triple crown burner These tops are designed for fitting on modular kitchen cabinets having a depth of between 550 and 600 mm. [. . . ]