User manual AEG-ELECTROLUX EHT796K

[. . . ] This appliance has been designed for cooking edible foodstuff and to be used for domestic nonprofessional purposes only. It must not be used for any other purpose. It is dangerous to alter the specification in any way. For hygiene and safety reasons, this appliance should be kept clean at all times. [. . . ] 160 mm. Big (rapid) Medium (semirapid) Small (Auxiliary) 33 2. Cleaning and Maintenance · Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Wash the enamelled components with warm soapy water. Never use abrasive cleaners Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. Carefully wash the stainless steel components with water, then wipe them dry with a soft cloth. If the marks are particularly difficult to remove, use common non-abrasive cleaners or specific products. In models provided with electric ignition, this feature is obtained through a ceramic "candle" and a metal electrode (fig. Keep these components well clean, to avoid difficult lighting, and check that the burner crown holes (lett. B) are not obstructed. PERIODIC MAINTENANCE Periodically ask your local Service Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. To ensure the good operation of the hob and its safety features, it is necessary that the taps are periodically lubricated. q The periodic lubrication of the taps must be carried out by qualified personnel, which you must refer to also in case of malfunctioning. FO 2110 Fig. Technical Data Gas Burners Rating Rapid Burner (big) 3 kW (G20-G25)) - 2, 8 kW (G30-31) Auxiliary Burner (small) 1 kW Semirapid Burner (medium) Category 2 kW II 2E+3+ CLASS 3 APPLIANCE Recess Dimensions Length Width Electric Supply 230 V 50 Hz Setting Natural Gas 20 mbar / G25 25 mbar Gas connection G 1/2" 550 mm. Electrical Connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the rating label); 2) check that the power supply is properly earthed in compliance with the current rules; 3) check the socket or the double pole switch used for the electrical connection can be easily reached with the appliance built in the forniture unit. The appliance is supplied with a connection cable. This has to be provided with a proper plug, able to support the load marked on the identification plate. To connect the plug to the cable, follow the recommendation given in Fig. The plug has to be fitted in a proper socket. If connecting the appliance directly to the electric system, it is necessary that you install a double pole switch between the appliance and the electricity supply, with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current rules. The connection cable has to be placed in order that, in each part, it cannot reach a temperature 50 °C higher than the room temperature. The brown coloured phase cable (fitted in the terminal block contact marked with "L") must always be connected to the network phase. [. . . ] 1/100 g/h - G30 g/h - G31 50 71 86 72 145 203 71 143 200 37 7. Building In A = Auxiliary burner R = Rapid Burner SR = Semirapid burner R A 580 FO 0815 500 Fig. 8 These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in Fig. 8. SR SR These hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in Fig. [. . . ]