User manual AEG-ELECTROLUX EHT9780K

[. . . ] English For your safety This new appliance is easy to use, however, make sure to read this handbook before installing and using it for the first time. In this way you can obtain best use, avoid incorrect operations, use the appliance in complete safety and respect the environment. . Installation · Appliance installation and connection to the power supply must only be carried out by QUALIFIED PERSONNEL. Before carrying out any operation, make sure the appliance is DISCONNECTED from the power supply. Make sure air can circulate freely around the appliance. [. . . ] The worktop grates can be placed in a dishwasher. For stubborn stains, use normal non-abrasive detergents or specific products, readily available on the market. DO NOT use scouring pads, steel wool or acids. Automatic ring lighting is ensured by the presence of a ceramic igniter plug and a metal electrode (Fig. Carefully clean these parts of the top periodically. Also, to prevent difficulty in lighting, make sure the burner cap holes are not clogged. To remove deposits from the burner cap holes (auxiliary and semirapid), remove the two fixing screws at the bottom of the cap and separate the two parts (Fig. After cleaning, reassemble the two parts and refit them correctly on the burner. After washing, refit the top grates, making sure they are correctly positioned. ACIDO FO 2094 Fig. 2 Worktop Clean the glass top regularly with a soft cloth soaked in lukewarm water and a little liquid detergent. Do not use the following products: - household detergents or bleaches; - soapy scouring pads not suitable for non-stick recipients recipients; - steel wool; - bath or sink stain removers. If the glass top is very dirty, use specific products available on the market. If you note breakage or cracks on the glass top, immediately disconnect the appliance, contact a Technical Assistance Centre and do not use the appliance until it is repaired. FO 2265 Fig. 3 16 Periodical maintenance Have the state and efficiency of the gas pipe and the pressure regulator (if present) periodically checked. If any anomalies are detected, have the faulty part replaced (and not repaired). To guarantee correct operation and safety, periodically grease the gas adjustment cocks. · Periodical lubrication of the cocks must only be carried out by QUALIFIED PERSONNEL; contact only qualified personnel in case of anomalies in appliance operation. Assistance and spare parts Before leaving the factory, the appliances are inspected and prepared by specialised personnel, in order to ensure best operating results. Any subsequent repairs or preparation becoming necessary must be carried out with maximum care and attention. Therefore it is advisable to always see your local dealer or the nearest Assistance Centre, specifying the type of problem, the appliance model (Mod. ), product number (Prod. This information is given on the plate located on the back cover, under the warranty terms. Original spare parts, certified by the product manufacturer, and identified by this mark, are only available at our Technical Assistance Centres and Authorised Spare Parts Shops. Warranty terms Your new appliance is covered by a warranty. The warranty terms are given in full in the documents placed inside the appliance. [. . . ] · When converting from LPG to natural gas, unscrew the by-pass pin 1/4 turn (approx. ). · In any case, the result must be a small and even flame on all the burner crown 5. Lastly, check that the burner does not go off when quickly turning the cock from max. The above adjustment operations can be easily performed, whatever the positioning or fixing of the cooktop to the cabinet. [. . . ]