User manual AEG-ELECTROLUX EID60010X

[. . . ] User Instructions 4 SPRINGS WATER CHILLER Undersink installation electrolux 3 Dear customer, thank you for choosing an Electrolux appliance. Thanks to its high quality, performances and reliability this appliance will make your everyday life comfortable, easy and safe. When designing our products we use the most updated technology, but we always respect the environment and the laws in force. Over 90% of our appliances are environmentally friendly classified as A, A+, and A++ and they are recommended by WWF. [. . . ] 5 Check the presence of the following in the undersink compartment: an intercepting tap for cold and hot water line. The lack of the above mentioned items makes the connection impossible. Please have your system checked by a plumber installer. Take the installation kit for water supply and carry out the connection as explained: 1. Replace hot water and cold water flexible pipes with the supplied kit (Fig. Connect the inlet pipe (H2O IN) to the cold water union "T"; 3. Connect the dispensing tap to the COLD H2O OUT pipe coming out of the appliance; 4. Connect the dispensing tap to the SODA OUT pipe coming out of the appliance. Fig. B primo avviamento electrolux 13 Installation of dispensing tap Model A The dispensing tap must be installed on the edge of the sink or on the kitchen top using the fixing ring or the predrilled base plate fixed with screws (Fig. 6 x x 14 electrolux installazione Model B The dispensing tap must be installed on the edge of the sink or on the kitchen top using the fixing ring (Fig. 7 primo avviamento electrolux 15 Installation of filter cartridge and Co2 Bottle Fig. 8 Open the filter cartridge access door as shown in Fig. 8, undoing the 2 fixing screws and pulling the panel towards the left, to remove the hooks from the fixed structure Remove the cap and connect the filter cartridge to the head rotating it counter-clockwise (Fig. In case of water leaks, dry the whole area with a cloth. 9 Disposable bottle Co2 bottle is on the left side of the appliance. Remove the green cap and screw the pressure reducer onto the bottle. Make sure the Co2 bottle is properly screwed (Fig. Open the valve on the reducer until reaching a pressure of approx. 4 bar to obtain a higher carbonation level. To reach a good carbonation level, it is necessary for CO2 pressure to be =. 5 bar higher than water pressure. Close the side door tightening its screws. Fig. 10 16 electrolux installazione Electrical connection and first starting Warning Before plugging in the appliance, make sure the system voltage and frequency match those on the identification plate and in the technical specifications table. 11 Only connect the appliance to a 230 V AC socket using the supplied plug. The electrical system must comply with all safety regulations in force. [. . . ] Any appliance or defective part replaced shall become the Company's property. This guarantee is in addition to your statutory and other legal rights. Exclusions Damage or calls resulting from transportation, improper use or neglect, the replacement of any light bulbs or removable parts of glass or plastic. Costs incurred for calls to put right an appliance which is improperly installed or calls to appliances outside the United Kingdom. [. . . ]