User manual AEG-ELECTROLUX EID60015X

[. . . ] Remove the green cap and screw the pressure reducer onto the bottle until fully tightened (Fig. 11). Open the valve on the reducer until it reaches a pressure of about 3 bar (Fig. 12). In order to obtain a higher level of CO2 concentration, it is possible to increase the pressure up to a maximum of about 4 bar. Rechargeable bottle The CO2 bottle can be found on the left side of the unit. [. . . ] For a complete assembly, screw the pressure reducer onto the adaptor. Open the valve on the reducer until it reaches a pressure of about 3 bar (Fig. 12). In order to obtain a higher level of CO2 concentration, it is possible to increase the pressure up to a maximum of about 4 bar. 12 Using the Refreshment Center Warning Use the general switch on the right side of the unit to switch it on. The on/off switch of the front panel does not have a standby function; the unit is still on, but all functions are disabled. To switch on and off the unit always use the internal general switch, even when resetting. 6 electrolux errata corrige Alarms Led indications Filter red led blinks slowly Meaning Filter is about to exhaust. 2, 700 liters of water have been dispensed. Please replace the filter cartridge as described in the paragraph "Filter replacement" Filter exhausted. 2, 800 liters of water have been dispensed. Please replace the filter cartridge as described in the paragraph "Filter replacement" All dispense buttons disabled. The limit has been reached of 2, 840 liters. After pulling out the unit it is easier to access the left side, where the CO2 bottle is installed; 2. hold the pressure reducer and turn the bottle clockwise (fig. 16) to separate the bottle from the pressure reducer; 4. screw the new bottle to the reducer counter-clockwise till fully tightened (Fig. lock the new bottle on the side of the unit. 16 errata corrige electrolux 9 Sanification + filter cartridge replacement if few days after the installation the filter replacement led turns on, please activate the sanitation procedure to restore all functions. In such case, filter replacement is not necessary When the "filter" led turns on, it is necessary to replace the cartridge filter as described below: 1. unblock the locking spring (Fig. 8) and pull out the Refreshment Center unit (Fig. 15); 2. turn off the unit through the main on/off switch; 3. rotate the exhausted cartridge clockwise about a quarter of a turn to remove it from the head (fig. 17) and extract it avoiding water spillage; 5. fill the sanification cartridge with "Neutral Detergent". Insert the sanitizing cartridge on the filter head by rotating it counter-clockwise about a quarter turn (Fig. 18); 6. [. . . ] in case of water spillage, dry the base and make sure there are no leaks; 7. place a big cup under the water dispense nozzle (the appliance will deliver round 250ml of water); 8. turn on the main switch pushing at the same time the light-switching button for approximately 5". Press the "light" button two more times, each time for 5". [. . . ]