User manual AEG-ELECTROLUX EIW60003X

[. . . ] Aligner installation After making sure that the overall size of the unit fits the cabinet space, install the base plate (Fig. 3). If necessary, please use the spacers to fix the base plate to the cabinet space (Fig. 4). Its function is to line up the Refreshment Centre to the other possible builtin appliances in the kitchen. Fig. [. . . ] To restore carbonated water dispensing, please replace the bottle as described in the paragraph "CO2 bottle replacement". Filter red led is on Filter red led stays lit Carbonated water led blinks slowly CO2 bottle led stays lit - Ambient water - ice cubes leds blink simultaneously Ice forming bin blocked. To reset the unit switch it off and then back on pushing the on/off button on the front panel. errata corrige electrolux 7 Led indications Meaning - Ambient water - cold water - carbonated water leds blink Volumetric turbine malfunctioning. The two possible causes simultaneously are: and fast 1. Lack of water supply from the water main; 2. Please check the presence of water supply to the unit. Turn unit off and then back on using the on/off switch on the front panel. - carbonated water - ambient water - cold water - ice cubes This alarm comes on only when the unit is turned on leds blink through the main on/off switch. It means that the main simultaneously tank is empty due to a lack of water supply from the main. To reset the unit, turn off the main switch on the side of the Refreshment Center. Check and make sure there is water supply to the unit, then turn the unit back on. All leds blink simultaneously All dispense buttons disabled. Presence of water on the base of the unit; 2. The water level inside the tank is too high. In the first case, switch off the unit and dry the base. In the second case, reset the unit by turning it off and then back on through the main switch on the side of the Refreshment Center. Maintenance and cleaning Please do not touch the front control panel with wet or oily hands, in order to avoid the malfunctioning of the touch control. 8 electrolux errata corrige Ice melting Do not block ice exit with any object, since it may damage the unit or prevent the correct closing of the exit. [. . . ] After this initial cleaning cycle, the unit will automatically dispense some cold and ambient water mixed with the sanitizing solution; Fig. turn off the unit through the main switch; 10. remove the sanification cartridge (Fig. 19) and connect the new filter cartridge to the head as shown on filter cartridge instructions (Fig. 20); 11. [. . . ]