User manual AEG-ELECTROLUX EK107000WL

[. . . ] This unit is not to be used by persons with reduced physical, sensory or mental capacity, or limited experience and understanding, other than when they are supervised or instructed in how to use this unit by a person responsible for their safety. Sed to ensure that they do not play with the unit. If you have been supplied with a damaged unit please contact your supplier immediately. Repairs and other service work must only be carried out by a service technician. [. . . ] A thick coating of ice reduces the effectiveness of the cold transfer to the frozen products. Keep the frozen products as cold as possible and well insulated during the defrosting time, e. Defrosting can be accelerated significantly if you place a bowl of hot water in the freezer compartment. Attention: do not use sharp implements to remove ice or anything hard frozen. do not use an electrical heater or an open flame for defrosting. ­ After defrosting clean the interior and dry it thoroughly. ­ Move the temperature back to Position Normal between the two temperature symbols. By pressing both holders sideways at the same time, the glass shelve can be swung upwards and removed. To fixture the glass shelf: push the glass shelf back into the holder and, at the front, press it down into the holder. Halved storage surfaces allow tall containers to be kept upright. For this, the front storage plate has to be pushed back into the slider groove underneath. It should be washed out from time to time with a mild soapy solution and then dried. an occasional wiping of the refrigerator with a vinegar solution suppresses odours and is recommended. Keeping the door seals clean stops them from sticking and thus avoids them being damaged. no scouring cleaners or scratching cloths are to be used. If the refrigerator has not been used for some time, set the ­temperature controller to position «0». Empty the refrigerator, defrost it, clean, and then leave the refrigerator as well as the freezer compartment open. ­ Be careful that no cleaning water can get into the controller housing (danger of short circuit). ­ Be careful that as little cleaning water as possible goes though the drainage channel into the collection dish. ­ Before being put back in use, the unit and the seals of the refrigerator and the freezer must all be completely dry. Tips The following points should be noted when using the new refrigerator: The unit should not be installed near heaters, radiators, or smoke ventilators, and should be protected from direct sunshine. A unit which has just been put into use needs approx. [. . . ] Where coolers are installed in open-plan kitchens or in partition walls, the level of operating noise will be heard more acutely. However, this is due to the surrounding architecture and not to a fault with the cooler. The level is dependent on the size of cooler. Normal operating noise as coolant flows through the circuit. [. . . ]