User manual AEG-ELECTROLUX EK11010LIWE

[. . . ] Please ensure that the piping of your appliance is not damaged before it is transported to the proper environmentallyfriendly disposal facility. For disposal of your old appliance, please contact the appropriate facilities of your local authorities. (Unfasten the hinges and remove the doors so that children playing cannot lock themselves in and be in mortal danger). disposal of the packing material All packing materials used are environmentally compatible and recyclable. [. . . ] This appliance is CFC and FC-free and contains small quantities of isobutane (R600a), an environmentally-friendly coolant. The electronics sense that products need to be frozen and the process control is carried out automatically. Leave the temperature control in the normal operating position, about 5 °C. Products for freezing should not be brought into contact with products which are already frozen. Products which have been thawed out must not be re-frozen because foodstuffs can spoil. Variable inner doors The cover inserts (Figure ;) in the inner doors can be adjusted somewhat and offer the option of a customized setting. To change the location of the inserts and bottle holder: first lift upwards and lift out, then set the required height and replace in the reverse sequence. Please note that the location of the cover of the uppermost cover cannot be adjusted. Ice which has formed on the back wall is melted (about once per day, see also the tips). The water flows out of the drainage channel (Figure =) and evaporates from the collection dish outside the appliance. Be sure to keep the collection channel and the drainage channel clean, so that the melted water can flow out easily. the storage of moisture-releasing foodstuffs leads to increased build-up of ice on the rear of the fridge and a reduction in cooling power. Tips The following points should be noted when using the new appliance: A appliance which has just been put into Do not install the unit near radiators, radiator pipes or smoke extractors and protect it as far as possible from direct sunlight Make sure the unit doors are kept open for as short a time as possible. The quicker the doors are closed again, the less cold is lost. 15 hours (with products) until it has reached its normal operating temperatures. If the doors are open for longer than 2 minutes then the lamp starts to flash. Make sure after closing that the doors are fully sealed. The cooling time for beverages and other products can take up to 6 hours from room temperature down to the cold room temperature. The warmer they are when put in, the longer this time will be. re-setting the temperature control has no effect on the cooling rate , only on the temperature reached. Condensation can form on the glass shelves if products are stored which emit water vapour. The electronic control defrosts the cold room only about once per day. [. . . ] Malfunctions The appliance is checked for trouble-free operation before being supplied. Should you have any problems please contact your nearest service facility, advising them of the model number and the details of the problem. a malfunction can occur if the electrical fuse is tripped. This problem can be solved easily if the fuse mechanism is re-activated. [. . . ]