User manual AEG-ELECTROLUX EK14011LBR

[. . . ] I Repairs and other service work must only be carried out by a service technician. I When cleaning switch off the power supply; pull out the power supply plug or deactivate the fuse. Never pull the plug out of the socket by pulling on the cable or with wet hands. Always grip the plug itself and pull it straight out of the power supply socket. [. . . ] Leave the temperature control in the normal operating position, about 5 °C. I Products for freezing should not be brought into contact with products which are already frozen. Products which have been thawed out must not be re-frozen because foodstuffs can spoil. Variable inner doors The cover inserts (Figure ;) in the inner doors can be adjusted somewhat and offer the option of a customized setting. To change the location of the inserts and bottle holder: first lift upwards and lift out, then set the required height and replace in the reverse sequence. Please note that the location of the cover of the uppermost cover cannot be adjusted. Ice which has formed on the back wall is melted (about once per day, see also the tips). The water flows out of the drainage channel (Figure =) and evaporates from the collection dish outside the appliance. Be sure to keep the collection channel and the drainage channel clean, so that the melted water can flow out easily. Clean out the drainage channel with the green cleaner provided using an up-and-down and turning motion. defrost the freezer compartment if the ice formation becomes excessive. I Allow warm or really hot products cool down outside the appliance. I Condensation can form on the glass shelves if products are stored which emit water vapour. I The electronic control defrosts the cold room only about once per day. A cat ice may be visible oftentimes at the back board of the cold room ­ this is though normal. I Be careful that products do not come into contact with the rear wall of the cold room so that they do not freeze to it and that, during defrosting, water does not get diverted into the cold room. Near heaters, radiators, or smoke ventilators, and should be protected from direct sunshine. I A appliance which has just been put into use needs approx. 15 hours (with products) until it has reached its normal operating temperatures. I Keep the appliance doors open for as short a time as possible. If the doors are open for longer than 2 minutes then the 32 ­ Oil and fats do not come into contact with the polymer parts and the door seals. ­ The coldest locations in the cold room for any setting of the temperature controller are at the back wall and above the lowest shelf. [. . . ] The appliance must be installed or built-in so that it is level and stable. Under no circumstances must tubing come into contact with a wall, other furniture or with another tubing. Where the appliances are installed in open-plan kitchens or in partition walls, the level of operating noise will be heard more acutely. However, this is due to the surrounding architecture and not to a fault with the appliance. [. . . ]