User manual AEG-ELECTROLUX EK5000

[. . . ] INSTRUCTION BOOK GAS COOKER 50x50 Model: EK 5000 0 CONTENTS Instructions for the user Warnings Technical Features Description of the appliance Use of the appliance Advice for use Maintenance and clening 2 4 5 6 10 11 Instructions for the installer Advice for safety Installation Specification nozzles 15 16 19 What to do if the appliance does not 13 work Guarantee conditions After sales service 14 14 How to read the instruction book ?The symbols bellow will guide you when reading the instruction book Safety instructions Description of operations step by step Advice and recommendation Information environment protection 1 WARNINGS It is very important that this instruction book should be kept safety for future consultation. If it should be sold or given to another person, please ensure that the booklet goes together with it, so that the new owner can know the functions of the machine and also be aware of the warnings. This warnings has been given for your and others safety. [. . . ] Off "" "" Maximum level Minimum level GAS Ignition 1. Lift the small lid on the bottom of the cavity, push and turn the control knob to the left to position maximum (fig. 1), maintain it pressed even after bringing near the flame (fig. Release the knob after 10 seconds and check that the burner is ignited through the holes in the bottom lid. If for any reason the flame should extinguish turn down the relevant knob and re-ignit it only after 1 minute at least. on maximum setting, than turn the knob to the desired position. Do not place cookware or foil directly on the oven base. fig. 2 Extinguishing of oven burner Turn the knob clockwise to mark « safety device is in place. THE HOB BURNERS The knobs for using the gas cooker are found on the control panel. The regulation knobs should be turned in anticlockwise direction until the small flame symbol, and vice-versa for the larger symbol. To the symbol on the knob corresponds a symbol on the control panel (fig. Off Maximum level Minimum level Do not close the cover till the plate is hot, the cover could be damaged. OVEN fig. 3 IGNITION: To ignite a burner, before positioning the saucepan, approach the burner with a flame, push the corresponding knob in completely and turn in an anticlockwise direction to the maximum position. Use the maximum level for boiling and the minimum for smothering and maintaining boiling. Choose always positions between the minimum and maximum, never between maximum and off. Extinguishing of burners Turn the knob clockwise to mark « safety device is in place. The How to chose the burner Above every knob there is a symbol for the corresponding burner. For better cooking results, always chose pans which properly fit to the diameter of the burner used (fig. We advise to lower the flame as soon as the liquid starts boiling. For a right ignition keep the burner ring and the sparklers always clean. The following diameters containers can be used: rapid burner 2, 60kW ­ min. 180 mm semi-rapid burner 2, 00kW ­ min. 120 mm auxiliary burner 1, 00kW ­ min. [. . . ] In case of intervention on your appliance ask your after sales service only spare parts certified by the Manufacturer. 14 INSTRUCTIONS FOR THE INSTALLER ADVICE FOR SAFETY · Before installation ensure that the local distribution conditions (gas nature and pressure) and the pre-setting of the appliance are consistent; This appliance must be installed only in a room with good ventilation; The adjusting conditions of this appliance are mentioned on the rating plate; This appliance is not connected to a flue gas exhaust device. It has to be installed and connected in accordance with the rules in force. Special attention should be granted to the applicable disposal concerning ventilation; The neighbouring furniture panels has to be heat proof or protected by such material. Installation and maintenance have to be made by a qualified person in accordance with the regulations in force, which are: · · · We deny any responsibility in cases of accidents or incidents caused lack of grounding or missgrounding. · Connection to gas main · Check that the counter flow and the diameter of piping are enough to supply all the appliances of the installation (take counsel with the gas distribution company); · Check that all connections are tight; · Install an accessible and visible barrage tap; · If you use a flexible pipe it has to be easily inspected all along and must not pass behind the appliance; · Change the flexible pipe little before it's expire date stamped on it. 15 INSTALLATION Placement Remove the plastic packaging and install the cooker in a dry, ventilated room (fig. [. . . ]