User manual AEG-ELECTROLUX EK5701W

[. . . ] Gas cookers INSTRUCTION BOOKLET Please read this instruction booklet before using the appliance Mod. EK 5701 35673-8301 GB 1 Important Safety Information You MUST read these warnings carefully before installing or using the appliance. If you need assistance, contact our Customer Care Department on 08705 950950 Installation q This cooker must be installed by qualified personnel, according to the manufacturer's instructions and to the relevant British Standards. q Unstable or misshapen pans should not be used on the hob burners as unstable pans can cause an accident by tipping or spillage. Never leave the cooker unattended when cooking with oil and fats. [. . . ] A build-up of fats or other foodstuffs could result in a fire, especially in the grill pan. Cleaning materials Before using any cleaning materials on your oven, check that they are suitable and that their use is recommended by the manufacturer. Cleaners that contain bleach should NOT be used as they may dull the surface finishes. External cleaning Regularly wipe over the control panel, oven door and door seal using a soft cloth well wrung out in warm water to which a little washing up liquid has been added. To prevent damaging or weakening the door glass panels avoid the use of the following: · Household detergent and bleaches · Impregnated pads unsuitable for nonstick saucepans · Brillo/Ajax pads or steel wool pads · Chemical oven pads or aerosols · Rust removers · Bath/Sink stain removers Clean the outer and inner door glass using warm soapy water. Should the inner door glass become heavily soiled it is recommended that a cleaning product such as Hob Brite, or Bar Keepers Friend is used. DO NOT clean the oven door while the glass panels are warm. If this precaution is not observed the glass panel may shatter. If the door glass panel becomes chipped or has deep scratches, the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Contact your local Service Centre who will be pleased to advise further. 14 Oven Cavity The enamelled oven cavity is best cleaned whilst the oven is still warm. Wipe the oven over with a soft cloth soaked in warm soapy water after each use. From time to time it will be necessary to do a more thorough cleaning, using a proprietary oven cleaner. Oven Shelves To clean the oven shelves, soak in warm soapy water and remove stubborn marks with a well wetted soap impregnated pad. Rinse well and dry with a soft cloth. Oven lamp replacement Disconnect the appliance. Unscrew the lamp and substitute it with another suitable for higher temperature (300°C) having the following characteristics: Voltage: Power: Connection: 230-240V (50Hz) 15W E14 FO 0424 Lid cleaning (EK 5701 W/GR only) The cooker lid can be disassembled, to allow a better cleaning(see fig. ). After a proper cleaning, carefully reposition the lid into its hinges. FO 0418 15 Cleaning around the flame spreader flap. -- Remove the smallremainder of the lid. When cleaning around the flame spreader, particles can fall into the drawer below. We recommend placing some paper over the contents of the drawer whilst cleaning. Please ensure the paper is removed after cleaning or it may ignite. We advise using a stiff dry brush to remove stubborn grease deposits around the base of the unit (see Fig. ). Remove any remaining surface fat with a sponge while the oven is still warm. Place a brush or other suitable cleaning implement into the aperture and brush around the base of the unit with a suitable detergent. [. . . ] C. THIS COOKER MUST BE EARTHED. -- Connect the green and yellow (earth) wire to the terminal in the plug which is marked with the letter 'E' or the earth symbol or coloured green and yellow. -- Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter 'N' or coloured black. -- Connect the brown (live) wire to the terminal in the plug which is marked with the letter 'L' or coloured red. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. [. . . ]