User manual AEG-ELECTROLUX EK5731W

[. . . ] Mixed fuel gas cookers INSTRUCTION BOOKLET Please read this instruction booklet before using the appliance Mod. EK 5731 35673-8401 GB 1 Important Safety Information You MUST read these warnings carefully before installing or using the appliance. If you need assistance, contact our Customer Care Department on 08705 950950 Installation q q This cooker must be installed by qualified personnel, according to the manufacturer's instructions and to the relevant British Standards. Unstable or misshapen pans should not be used on the hob burners as unstable pans can cause an accident by tipping or spillage. Never leave the cooker unattended when cooking with oil and fats. [. . . ] A well moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove. After cleaning, be sure to wipe dry with a soft cloth. 12 Cleaning the Oven The oven should be kept clean at all times. A build-up of fats or other foodstuffs could result in a fire, especially in the grill pan. Cleaning materials Before using any cleaning materials on your oven, check that they are suitable and that their use is recommended by the manufacturer. Cleaners that contain bleach should NOT be used as they may dull the surface finishes. External cleaning Regularly wipe over the control panel, oven door and door seal using a soft cloth well wrung out in warm water to which a little washing up liquid has been added. To prevent damaging or weakening the door glass panels avoid the use of the following: · Household detergent and bleaches · Impregnated pads unsuitable for nonstick saucepans · Brillo/Ajax pads or steel wool pads · Chemical oven pads or aerosols · Rust removers · Bath/Sink stain removers Clean the outer and inner door glass using warm soapy water. Should the inner door glass become heavily soiled it is recommended that a cleaning product such as Hob Brite, or Bar Keepers Friend is used. DO NOT clean the oven door while the glass panels are warm. If this precaution is not observed the glass panel may shatter. If the door glass panel becomes chipped or has deep scratches, the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Contact your local Service Centre who will be pleased to advise further. 13 Oven Cavity The enamelled oven cavity is best cleaned whilst the oven is still warm. Wipe the oven over with a soft cloth soaked in warm soapy water after each use. From time to time it will be necessary to do a more thorough cleaning, using a proprietary oven cleaner. Oven Shelves To clean the oven shelves, soak in warm soapy water and remove stubborn marks with a well wetted soap impregnated pad. Rinse well and dry with a soft cloth. Oven lamp replacement Disconnect the appliance. Unscrew the lamp and substitute it with another suitable for higher temperature (300°C) having the following characteristics: Voltage: Power: Connection: 230-240V (50Hz) 15W E14 FO 0424 Lid cleaning (EK 5731 W/GR only) The cooker lid can be disassembled for easier cleaning (see fig. ). After cleaning, carefully reposition the lid into its hinges. FO 0418 14 Something Not Working If the appliance is not working correctly, please carry out the following checks, before contacting your local Electrolux Service Centre. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. SYMPTOM s There is no spark when lighting the gas SOLUTION x Check that the unit is plugged in and the electrical supply is switched on x Check that the RCCB has not tripped (if fitted) x Check the mains fuse has not blown x Check the burner cap and crown have been replaced correctly, e. g. x Check the main jet is not blocked and the burner crown is clear of food particles. x Check the burner cap and crown have been replaced correctly, e. g. x Check a cooking function / temperature have been selected. [. . . ] The cooker is supplied with a 3 core flexible supply cord incorporating a 13amp plug fitted. In the event of having to change the fuse, a 13amp ASTA approved (BS 1362) fuse must be used. Should the plug need to be replaced for any reason, the wires in the mains lead are coloured in accordance with the following code: Green and Yellow - Earth Blue - Neutral Brown - Live Ensure that the cooker supply cord does not come into contact with surfaces with temperatures higher than 50 deg. C. THIS COOKER MUST BE EARTHED. -- Connect the green and yellow (earth) wire to the terminal in the plug which is marked with the letter 'E' or the earth symbol or coloured green and yellow. [. . . ]