User manual AEG-ELECTROLUX EK6468B2

[. . . ] S High proof alcohol must only be stored Well sealed and upright; further, do not store explosive materials in the unit. S When operating the unit, care must be Taken that the cooling circuit does not get damaged. Should the cooling circuit get damaged then keep it clear of open fires and any type of ignition source. The room in which the unit is located should be ventilated for a few minutes. [. . . ] S Only small quantities should be frozen at One time so that the temperature in the freezer does not increase too much (max. The electronics sense that products need to be fro34 Ught into contact with products which are already frozen. Products which have been thawed out must not be re-frozen because foodstuffs can spoil. Variable inner doors The cover inserts in the inner doors can be adjusted somewhat and offer the option of a customized setting. To change the location of the inserts and bottle holder: first lift upwards and lift out, then set the required height and replace in the reverse sequence. Ice which has formed on the back wall is melted (about once per day, see also the tips). the water flows out of the drainage channel (fig. =) and evaporates from the collection dish outside the refrigerator. Be sure to keep the collection channel and the drainage channel clean, so that the melted water can flow out easily. Clean out the drainage channel with the green cleaner provided using an up-and-down and turning motion. defrost the freezer compartment if the ice formation becomes excessive. Make sure after closing that the doors are fully sealed. Other products can take up to 6 hours from room temperature down to the refrigerator temperature. The warmer they are when put in, the longer this time will be. Shelves if products are stored which emit water vapour. Tor only defrosts about once per day, the ice formation on the rear wall in the refrigerator itself can be more marked than is usual in previous refrigerators. S Be careful that products do not come Into contact with the rear wall of the refrigerator so that they do not freeze to it and that, during defrosting, water does not get diverted into the refrigerator. With liquids; never measure the air temperature. ­ Oil and fats do not come into contact with the polymer parts and the door seals. ­ The coldest locations in the refrigerator for any setting of the temperature controller are at the back wall and above the lowest shelf. Sensitive products should therefore be put on the lowest shelf. & Changing the light bulb A defective bulb must be replaced at once. [. . . ] it becomes quieter as the operating period continues. Noises which are not normal Unusual noise is normally the result of improper installation. The cooler must be installed or built-in so that it is level and stable. Under no circumstances must tubing come into contact with a wall, other furniture or with another tubing. [. . . ]