User manual AEG-ELECTROLUX EK67000REWE

[. . . ] S If you have been supplied with a dama- Ged unit please contact your supplier immediately. S Repairs and other service work must only S When cleaning switch off the power Supply; pull out the power supply plug or deactivate the fuse. Never pull the plug out of the socket by pulling on the cable or with wet hands. Always grip the plug itself and pull it straight out of the power supply socket. [. . . ] A thick coating of ice reduces the effectiveness of the cold transfer to the frozen products. Keep the frozen products as cold as possible and well insulated during the defrosting time, e. = Defrosting can be accelerated significantly if you place a bowl of hot water in the freezer compartment. Attention: do not use sharp implements to remove ice or anything hard frozen. do not use an electrical heater or an open flame for defrosting. ­ After defrosting clean the interior and dry it thoroughly. ­ Move the temperature back to Position Normal between the two temperature symbols. By pressing both holders sideways at the same time, the glass shelve can be swung upwards and removed. To fixture the glass shelf: push the glass shelf back into the holder and, at the front, press it down into the holder. cleaning The refrigerator is to be kept clean for the hygienic storage of foodstuffs. It should be washed out from time to time with a mild soapy solution and then dried. an occasional wiping of the refrigerator with a vinegar solution suppresses odours and is recommended. Keeping the door seals clean stops them from sticking and thus avoids them being damaged. no scouring cleaners or scratching cloths are to be used. If the refrigerator has not been used for some time, set the ­temperature controller to position «0». Empty the refrigerator, defrost it, clean, and then leave the refrigerator as well as the freezer compartment open. ­ Be careful that no cleaning water can get into the controller housing (danger of short circuit). ­ Be careful that as little cleaning water as possible goes though the drainage channel into the collection dish. ­ Before being put back in use, the unit and the seals of the refrigerator and the freezer must all be completely dry. Tips The following points should be noted when using the new refrigerator: S The unit should not be installed near Heaters, radiators, or smoke ventilators, and should be protected from direct sunshine. S A unit which has just been put into use 15 hours (with products) until it has reached its normal operating temperatures. If the doors are open for longer than 2 minutes then the refrigerator lamp starts to flash. [. . . ] Where coolers are installed in open-plan kitchens or in partition walls, the level of operating noise will be heard more acutely. However, this is due to the surrounding architecture and not to a fault with the cooler. The level is dependent on the size of cooler Normal operating noise of the fan Normal operating noise as coolant flows through the circuit Normal operating noise as coolant is injected into the condenser Normal switching sound of the electromechanical temperature controller Shelves, baskets, Position the interior parts so that they don't touch one fitted holders, refrianother, or so that they are fitted securely. Electrical safety (personnel protection safety) is to be ensured during fitting. [. . . ]