User manual AEG-ELECTROLUX EKG510106W

[. . . ] The appliance should be serviced by an authorised Service Engineer and only genuine approved spare parts should be used. It is important that the appliance is suitable for your gas supply. Your installer should check the rating plate. Make sure that a stability bracket is fitted. [. . . ] Prime cuts of meat do not benefit from slow cooking. Remove excess fat and skin unless it is browned first. Milk puddings · Cover the cereal with boiling water and leave it to stand for 30 minutes. Drain and make the pudding in the usual way. · · · · · General points Frozen Foods Thaw thoroughly before cooking. Thickening Toss meat in flour for casseroles. Alternatively blend cornflour with water and add it at the end of cooking. Soups, stews · · · · casseroles and Do not cook casseroles over 2. 7 kg (6lb). Bring to the boil on the hotplate then cook on slow cook. Cook on the middle shelf of the oven or above. Cover food with a tight fitting lid or tin foil. Flavouring Flavours are held in the food because there is little evaporation. Adjust flavouring at the end of the cooking time. Vegetables · · Cut into small pieces. Dried beans must be pre-soaked then boiled in an open pan for 15 minutes before adding to any dish. Place vegetables under meat in casseroles. Cover food with a tight fitting lid or tin foil. Liquid Use slightly less liquid as there is little evaporation during cooking. However the surface will dull with time. After cleaning the appliance parts, dry them thoroughly before you put them back. When replacing hotplate burner parts 1. (Do not try to force the crown on to the body). Make sure that the hole in the crown is over the electrode. Check that the location pegs sit in the slots in the body. When the crown is in this position let it fall freely on to the body. Check that the crown can be moved slightly from side to side. 2. Place cap centrally on the top of crown (enamel side up). Move sideways and front to back to check the cap is properly fitted. If a burner will not light then you need to check the crown and cap positions. 26 Cleaning the shelves and grill/oven furniture Hints and tips Aerosol cleaners must not be used on Stayclean surfaces. [. . . ] The pressure must be set to 28 mbar for use on butane or 37 mbar for use on propane. Checking lid shut-off device 1. Turn one hotplate tap to its full on position and push the ignition button. There should now be no gas supply to the hotplate and the burner will go out. The gas supply should now be restored to the hotplate, when the tap is turned on. 4. [. . . ]