User manual AEG-ELECTROLUX EKG5543XN

[. . . ] USER MANUAL Model EKG5542/EKG5543 IMPORTANT SAFETY INFORMATION These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using the appliance. If you are unsure about any of the information in this book contact the Customer Care Department. When you are lighting any burner check that it is lit before you leave the appliance. [. . . ] ANY OTHER CLEANING MATERIALS MAY DULL THE SURFACE FINISH. REMOVING AND REPLACING THE WIREWORK RUNNERS 1. Remove all shelves and furniture from the oven. Hold the wirework at the bottom, unclip from the cavity side and gently pull towards the centre of the oven. Unhook the runner at the top and remove from the cavity. To replace the runners, hook the wirework side runner into the cavity, slide back and press into place. Ensure the wirework runners are firmly in position before replacing the oven shelves. SIDE PANEL CAVITY CENTRE 17 CLEANING THE HOB Clean the hotplate top using a mild abrasive. Take care not to damage the spark electrodes. If the spark electrodes are damaged the burners will not light. You can remove the pan supports, burner caps and burner crowns to clean them. Again take care not to damage the spark electrodes. Clean the burner crowns and pan supports by soaking them in very hot soapy water. Aluminium based saucepans can leave shiny metal marks on the pan supports. You can remove any stubborn stains by scouring with a soap impregnated steel wool pad. If you look after the burner crowns and pan supports in this way they will stay reasonably clean. However the surface will dull with time. After cleaning the appliance parts, dry them thoroughly before you put them back. WHEN REPLACING HOTPLATE BURNER PARTS 1. (Do not try to force the crown on to the body). Make sure that the hole in the crown is over the electrode. Check that the location pegs sit in the slots in the body. When the crown is in this position let it fall freely on to the body. Check that the crown can be moved slightly from side to side. [. . . ] Check the supply pressure by turning the Rapid burner on and one other hotplate burner full on and light the appropriate burner. The pressure should be either:(i) For Natural Gas 20mbar (ii) For LP. The pressure must be set to 29 mbar for use on butane or 37 mbar for use on propane. Turn off the taps, disconnect the pressure gauge. [. . . ]