User manual AEG-ELECTROLUX EKK61500OW

[. . . ] You've chosen a product that brings with it decades of professional experience and innovation. ingenious and stylish , it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you'll get great results every time. Visit our website for: Get usage advice, brochures, trouble shooter, service information: www. [. . . ] The storage compartment can become hot when the appliance operates. Let the appliance operate without the food for approximately 1 hour. Let the appliance operate without the food for approximately 10 minutes. Let the appliance operate without the food for approximately 10 minutes. This is to burn off the residue in the appliance. The accessories can become more hot than usually. When you pre-heat the appliance for the first time, the appliance can make an odour and smoke. Be very careful when you use open fire in kitchen environment. the manufacturer declines any responsibility in case of misuse of the flame. Always light the burner before you put cookware on it. Push the knob for the necessary burner down completely and turn it to the . When you maximum position push the knob, the spark generator starts automatically. If after some tries the burner does not light, check if the crown and its cap are in the correct positions. Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 minute. You can light the burner without electrical device (e. To do so, put the flame near the burner, push the related control knob down and turn it counterclockwise to the maximum gas release position. If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute. The spark generator can start automatically when you switch on the mains, after installation or a power cut. To put the flame out, turn the knob to the symbol . Always turn the flame down or switch it off before you remove the pans from the burner. Turn off all burners before shutting the lid. [. . . ] Once installation is complete, check the perfect seal of every pipe fitting, using a soapy solution, never a flame. Before gas connection disconnect the mains plug from the mains socket or switch off the fuse in the fuse box. The appliance is set to default gas, to change the setting choose pipe holder from the list. Let only an authorized person do the adjustment to different types of gas. [. . . ]