User manual AEG-ELECTROLUX EKM6717X

[. . . ] Mixed-Fuel Cooker INSTRUCTION BOOKLET Mod. EKM 6717 X 35692-0501 PH-VN-TH Important safety information This warnings has been given for the safety of you and others. We therefore ask you to carefully read the procedures of installing and using this cooker. Installation · · The work of installation must be carried out by competent and qualified installers according to the regulations in force. Any modifications to the domestic electrical mains which may be necessary for the installation of the appliance should be carried out only by competent personnel. [. . . ] With this cooking method, through the elimination of humidity in the air and a drier environment, smells and tastes are not given off and do not mix with those of other dishes. Thanks to this possibility of cooking on several levels, you can cook up to three different dishes at the same time, to be consumed immediately or frozen. In this case, it is advisable to place the dish on the lower level for better cooking control. This oven is particularly suitable for defreezing rapidly, sterilizing preserves, homemade jams and, finally, for drying mushrooms and fruit. Cooking in the multi-function oven This type of oven permits difrferent types of cooking: traditional, fanned heat and grilling; cooking can therefore be optimized. Using the oven For the cooking of cakes Pre-heat the oven, unless indicated differently, for at least 10 minutes before use. Do not open the oven door when cooking dishes which must raise (e. g. raised pastries and soufflés); the jet of cold air would block the raising process. To check if cakes are cooked, insert a toothpick into the mixture; if it comes out clean the cake is ready. Wait until at least 3/4 of the cooking time has passed before doing this check. As a general rule remember that: a dish which is well-cooked on the outside but not sufficiently cooked inside would have required a lower temperature and longer cooking time. On the contrary, a "dry" texture would have required a shorter time and higher cooking temperature. 13 For the cooking of meat Meat to be cooked in the oven should weigh at least 1 kilo to avoid its becoming too dry. If you want roasts with a good colour, use very little oil. If the piece is lean, use oil or butter or a little of both. Butter or oil are on the other hand unnecessary if the piece has a strip of fat. If the piece has a strip of fat on one side only, put it in the oven with this side upwards; when melting the fat will grease the lower side sufficiently. Red meat should be removed from the fridge one hour before cooking otherwise the sudden change of temperature could cause it to become tough. A roast, especially if of red meat, must not be salted at the beginning of cooking as salt causes juices and blood to seep out of the meat, thus preventing the formation of a well-browned crust. It is advisable to salt the outside of the meat after just over half the cooking time. Place the roast in the oven in a dish having a low rim; a deep dish shields heat. Meat can be placed on an ovenproof dish or directly on the grill, under which the dripping pan will be inserted to collect juice. Ingredients for gravy should only be put in the dish immediately if cooking time is brief, otherwise they should be added during the last half hour. Begin cooking rare meat at a high temperature, reducing the temperature to finish cooking the inside. The cooking temperature for white meat can be moderate throughout. [. . . ] The manufacturing company release the unit, once tested, adjusted for the kind of gas stated on the rating plate located on the back of the range, next to connection pipe. Be sure that you are going to connect the unit to the same kind of gas written on the rating plate. For best efficiency and lowest consumption, be sure that manifold gas pressure respects the values in the table of burners characteristics. Connection using a rigid pipe or a flexible metal pipe To ensure higher safety, it is recommended to carry out the connection to the gas system using rigid pipes (ex. copper) or using flexible stainless steel pipes, to avoid any stress to the unit. [. . . ]