User manual AEG-ELECTROLUX EKM9940X

[. . . ] Consult the instructions booklet before installing and using the appliance. - This household appliance has been designed for cooking and it must therefore be used for this purpose only. This appliance is marked according to the Europeandirective 2002/96/EC on Waste Electricaland Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negativeconsequences for the environment and humanhealth, which could otherwise be caused byinappropriate waste handling of this product. ATTENTION: The use of a gas cooking appliance results in the production of heat and moisture in the room in which it is installed. Ensure that the kitchen is well ventilated : keep natural ventilation holes open or install a mechanical ventilation device (mechanical extractor hood). [. . . ] When the cooking end time is reached, the relay and cooking time symbol switch off, the acoustic signal sounds and the AUTO symbol flashes. Semi-automatic use to set end time Press the end time button. The AUTO and cooking time symbols light up continuously. When the cooking end time is reached, the relay and the cooking time symbol switch off. When the cooking time is finished, the AUTO symbol flashes, the acoustic signal sounds and both the relay and the cooking time button switch off. Automatic use to set cooking time and end time Press the cooking time button and select the duration of the cooking time with + or - button. The AUTO and cooking time symbols light up continuously. When the cooking end time button is pressed the next cooking end time is shown on the display. The relay and the cooking time symbol switch off. The symbol lights up again when the cooking start time is reached. When the cooking time is finished, the AUTO symbol flashes, the acoustic signal sounds and both the cooking time symbol and the relay switch off. Remember that the quantity of air necessary for combustion must never be less than 2m3/h for each kW of power (see total power in kW on the appliance data plate fig. 50 mm min. 100 mm "0" mm "0" mm Location Your cooker is heavy, so be careful when moving or positioning it. Do not try to move the cooker by pulling on the doors, handles or control panel. The cooker is designed to "slot in" between 600mm deep cabinets, spaced approximately 1000mm apart. It can also be used free-standing, with a cabinet to one side, in a corner setting or with its back to a wall. In case of installation between kitchen units, their sides must withstand a temperature of at least 90 degrees C. The wall behind the cooker and 450mm above and across the width of the cooker, should be an incombustible material or easy clean 895 surface such as ceramic tiles. Any overhanging surface or cooker hood should be at least 650mm (30") above the cooker hob. We do not recommend positioning the cooker below wall cupboards, as the heat and steam from the cooker may cause damage to the cupboard and its contents. The cooker may be located in a kitchen, or a bed-sitting room, but not in a room containing a bath or shower. The cooker must not be installed in a bed-sitting room of less than 20m3 . [. . . ] Never heat up unopened food containers as pressure can build up causing the container to burst. Never store chemicals, food stuffs, pressurised containers in or on the cooker, or in cabinets immediately above or next to the cooker. Never fill a deep fat frying pan more than1/3 full of fat or oil and never use a lid with this type of pan. NEVER LEAVE PANS UNATTENDED WHILE COOKING. [. . . ]