User manual AEG-ELECTROLUX EL7020B

[. . . ] Do not use to pick up flammable or combustible liquids such as gasoline, or use in areas where they may be present. Store your cleaner indoors in a cool, dry area. Always turn off this appliance before connecting or disconnecting either hose, wand or motorized nozzle. Hold plug when rewinding onto cord reel. [. . . ] The Aeropro system consists of a hose, handle, tube and nozzle specifically designed for your UltraOne and which may vary from model to model. Pay special attention to the Safety advice chapter. Display HEPA filter cover HEPA filter Parking slot Power cord Motor filter Motor filter holder S-bag® Dust compartment cover Button for Aeropro 3in1 compartment and dustbag comparment Aeropro 3in1 compartment Aeropro 3in1 nozzle Aeropro hose Handle Aeropro telescopic tube Parking clip Display for models with manual control* Aeropro classic handle* Aeropro ergo handle* Aeropro nozzle* Display for models with remote control* Aeropro remote control handle* Aeropro remote control handle for motorized nozzle* Aeropro motorized nozzle* Aeropro turbo nozzle* Aeropro parketto nozzle* Deep Clean Power Nozzle * Accessories may vary from model to model. Insert the hose (to remove it, press the lock buttons and pull the hose out). Attach the telescopic tube to the floor nozzle (to remove it, press the lock button and pull the nozzle off). Attach the telescopic tube to the hose handle (to remove it, press the lock button and pull the hose handle out). Adjust the telescopic tube by holding the lock with one hand and pulling the handle with the other hand. Pull out the power cord and plug it into the outlet. Models with remote control can also be operated by the ON/OFF button on the handle. Models with manual regulation Push +/- button with your hand to adjust suction power. The cleaner starts in auto-function (automatic suction power regulation). To close the lid, insert the front hooks in the rails, push the lid forward and press down. Should be done with every 3rd replacement of the s-bagTM. Replace the motor filter when dirty or after every 3rd s-bag®. Push the filter holder down and pull it out. Belt pulleys can become hot during normal use. Flip power head over onto its top and remove the four screws marked by numbers A, B, C, D in Fig. Pull up and rotate forward to release the base plate. Place new belt around brushroll motor pulley. Place other end of the belt around the brushroll. Insert the belt end of the brushroll back into the case, followed by the other end. Reinstall the cover by "snapping" it back into place and replacing the four screws. [. . . ] Any warranty that may be implied in connection with your purchase or use of the cleaner, including any warranty of Merchantability or any warranty for Fitness For A Particular Purpose is limited to the duration of this warranty. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. Your relief for the breach of this warranty is limited to the relief expressly provided above. In no event shall Electrolux be liable for any consequential or incidental damages you may incur in connection with your purchase or use of the cleaner. [. . . ]