User manual AEG-ELECTROLUX EL7055A

[. . . ] The Oxy3system should only be used by adults for normal domestic cleaning indoors. A safety device is fitted, which prevents the cover closing without a s-bag®. Fluids (this can cause serious damage to the machine). Fine dust, for example from plaster, concrete, flour, hot or cold ashes. [. . . ] If you have a vacuum cleaner with remote control*, make sure that the switch is pressed in properly. 4a Pull out the power cable and plug into the mains. 4b Press the carrying handle to rewind the cable (hold the plug to prevent it striking you). 5 Some vacuum cleaners, depending on the model, are equipped with an automatic cable winder (autoreverse). pull out the cable and plug in the vacuum. Move the control backwards in order to wind the cable in and out as required. Move it forwards to lock the cable once it is at the required length. 7 If you have a vacuum cleaner with remote control* the machine is started by gently pressing the auto or min button. in the auto-position the suction power is automatically adjusted depending on the surface. Increase the suction power to maximum power by pressing in the auto button for three seconds or more. Turn off the vacuum cleaner by pressing the off button. 5 Insert a new s-bag® by pushing the cardboard to the end of the grooves in the holder, you will feel a "click". replace the holder and close the cover. NB: Change the s-bag® even if it is not full ( it may be blocked) and after using the carpet cleaning powder. 1b Replace the filter for every 5th s-bag® or when the indicator lamp is illuminated 2 Remove the hose and open the lid. 3 Remove the dustbag holder 6 Open the filter holder for the motor filter and fold it forward. 7 Carefully remove the dirty filter and replace it with a new one. 8 Press the filter holder back until it clicks into place. 9 Replace the dustbag holder (including s-bag®) and close the cover. A safety catch prevents the filter holder from closing without the motor filter fitted. The vacuum cleaner automatically stops if there is a blockage in the nozzle, tubes or hose or if the filter or dustbag become blocked. Disconnect from the mains and allow the vacuum cleaner to cool down for 20-30 minutes. [. . . ] 4a Remove the wheels and axles by pulling them right out. Remove dust-balls, hair or anything else that may have got stuck. Use the crevice nozzle to clean the wheel axles. reassemble the wheels by pressing them tightly together. [. . . ]