User manual AEG-ELECTROLUX ENB34010W8

[. . . ] We were thinking of you when we made this product Welcome to the world of Electrolux Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. You find some examples on the cover in this manual. Please take a few minutes to study this manual so that you can take advantage of the benefits of your new machine. [. . . ] These changes might cause a cracking noise, which is a natural, harmless phenomenon. Should you want to check the temperature of food stored in the refrigerator, set the thermostat knob into a medium position, place a glass of water centrally in the cabinet, and put a proper thermometer with an accuracy of +/- 1°C into it. when the surface temperature of the cooling surface has reached +3 - +4 °C the thermostatic control restarts operation of the system. Melting water flows through defrost water outlet leaded through the back into the evaporator tray maintained on the top of Check and clean the outlet of melting water coming during defrosting regularly - a label inside the appliance warns you for this. If it is clogged the melting water gathered can cause earlier failure as it can go to the insulating of the appliance. Clean the melting water outlet with the supplied pipe scraper that can be seen in the figure. the pipe scraper has to be stored in the outlet. The most typical case of clogging up in the melting water outlet when you put food wrapped in some paper into the appliance and this paper contacts back plate of the refrigerator and freezes to it. If you remove the food right at this moment the paper will tear and it can cause clogging up in the outlet by getting into it. So you are asked to be careful because of the above - when placing foods wrapped in paper into the appliance. During heatwaves, the refrigerator temporarily happens to operate constantly - during this the automatic defrosting does not work. Remaining small ice and frost stains on back plate of the refrigerator after defrosting period is not abnormal. It is recommended to wash the inside of the refrigerator in 3-4 weeks time using lukewarm water then wipe it (it is practical to clean the inside of the freezer and defrost it at a time). household cleaner or soap must not be used. After breaking the circuit wash the appliance with lukewarm water then wipe it. after cleaning apply voltage to the appliance. It is recommended to remove the dust and dirt collected on the back of the refrigerator and the condenser and to clean the evaporative tray on top of the compressor once or twice a year. Should the light fail to work you can change it as below: Break the circuit of the appliance. Unscrew the screw holding the cover (1), press the rear hook (2) and at the same time slide the cover in the direction indicated by arrow (3). (Bulb type: 230-240 V, 15 W, E 14 thread) After changing the bulb replace the cover, snap it in place, screw back the screw and apply voltage to the appliance. When the refrigerator is not in use In case the appliance will not be used for a long time follow these steps: Break the circuit of the appliance. Leave the door open to avoid a build up of air inside. [. . . ] Nor will the guarantee cover those caused by inadequate installation or assembly, lack of maintenance or failure to respect the assembly instructions or directions for use. Defects that result from repairs or measures carried out by people who are not qualified or expert or defects that result from the addition of nonoriginal accessories or spare parts are not covered by the guarantee. Appliances that are easy to transport may be delivered or sent to the consumer services department. Home repairs are only anticipated for bulky appliances or built-in appliances. [. . . ]