User manual AEG-ELECTROLUX ENB38607X8

[. . . ] We were thinking of you when we made this product Welcome to the world of Electrolux Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. You find some examples on the cover in this manual. Please take a few minutes to study this manual so that you can take advantage of the benefits of your new machine. [. . . ] An increase in the temperature in the freezer compartment (for example due to an power failure) is indicated by: - flashing temperature; - freezer compartment flashing ; - flashing of the icon ; - sounding of buzzer. When normal conditions are restored: - the acoustic signal shuts off; - the temperature value continues to flash; When you press key "E" to de-activate the alarm, the highest temperature reached Some useful information and advice The variable shelves are worth paying attention to, which increases the usability of the fresh food compartment considerably. rearranging the shelves is also possible when the door is open at an angle of 90°. After opening and closing the door of freezer vacuum will rise inside the appliance because of the low temperature. So wait 2-3 minutes after closing the door - if you want to open it again - while inner pressure equalises. Take care of opening the freezer at a position of thermostatic control so that the inside temperature can never be warmer than -18°C. It is practical to make sure of faultless operation of the appliance daily so as to notice possible failure in time and prevent deterioration of frozen foods. Normal operating sounds: A thermostat controls the compressor and you will hear a faint click when thermostat cuts in and out. You may hear faint gurgling or bubbling sound when the refrigerant is pumped through the coils at the rear, to the cooling plate/evaporator. When the compressor is on, the refrigerant is being pumped round and you will hear a whirring sound or pulsating noise from the compressor. The fridge evaporator (this part cool down the fridge section) is foamed into the cabinet. This part changing during its work, and parallel with this its dimensions are slightly changing, too. These changes might cause a cracking noise, which is a natural, harmless phenomenon. Should you want to check the temperature of food stored in the refrigerator, set the thermostat knob into a medium position, place a glass of water centrally in the cabinet, and put a proper thermometer with an accuracy of +/- 1°C into it. If after 6 hours you measure a value between +3°C and +8°C, the refrigerator works properly. the measuring shall be performed under steady-stated conditions (without changing the load). If the freezer temperature is measured using a thermometer, put it between the products since this will reflect the real temperature in the frozen products. In this chapter practical hints and ideas are given about how to use the appliance to reach maximum energy saving and there is environmental information about the appliance as well. How to save energy Avoid putting the appliance in a sunny place and near anything that gives off heat. Be sure that the condenser and the compressor are well ventilated. Do not cover the sections where ventilation is. wrap products in tightly closing dishes or cling film to avoid building up unnecessary frost. [. . . ] Parts replaced free of charge become our property. So as to avoid more severe damage, the defect must be brought to our attention immediately. Applying the guarantee is subject to the consumer providing proof of purchase showing the purchase and/or delivery date. The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. [. . . ]