User manual AEG-ELECTROLUX ENB3900M

[. . . ] 21 - 22 Changing the opening directions of the doors pág. 23 Regulation and Control pág. 24 - 25 How to use your Fridge-Freezer pág. 26 - 27 Maintenance of your Fridge-Freezer pág. [. . . ] For further information see sention on temperature alarm). 2 The door alarm If either of the doors is left open for a prolonged period of time the door alarm will start to beeb and a red flashing light will go on. Pressing the alarm button will switch the buzzer off and the light will stop flashing, but remain red. If you simply shut the doors, this will also switch off the door alarm buzzer and the light automatically. 5 On/Off button To make the product work press the ON/OFF button continuosly for 3 seconds. To switch the product off press the button continuously for 3 seconds. When the product has been plugged in and the button pressed for the 3 seconds, the button will light up in green. If the ON/OFF button is green the freezer knob and fridge knob will also be lit up. 3 Temperature alarm If the internal temperature has risen significantly the temperature alarm will sound and the light will start to flash. To switch the alarm off simply press the temperature alarm button. This will stop the buzzer and the red light will stop blinking and remain red. The temperature alarm may go on because: a. - The doors have been left open. c. - More than the recomended amount of food has been put in at one time. d. - You need to set the temperature controls to a colder position. If the alarm goes on constantly you should contact you TECHNICAL OFICIAL SERVICE. 6 Fridge control Setting the knob to the standby position when the freezer is working, but the fridge if not being used, (for example when you go on holiday), will help you to reduce energy consumption. The fridge door however must be kept closed. By turning the knob clockwise you will progressively cool down the fridge. Position 5 is the coldest setting possible. If neither the fridge nor the freezer are being used (i. e. The appliance switched off), both doors should be left open. This will help to avoid any possible smells caused by high levels of humidity. 24 Regulation and Control Interior light: Switches on when opening the door of the refrigerator compartment and switches off when closing the door. Switch the appliance off by pressong ON/OFF button, and them unplug it. Firstly open the plastic light cover by pushing upwards with your thumb on the centre clip. The cover will then swing down and you can remove and replace the bulb(s). A Standard bulbs If your fridge has two bulbs you should use 25 watt standard bulbs (maximum wattage) with an E14 socket. Under no circumstances should halogen bulbs be used. [. . . ] · Re-adjust. D) NOISES · Appliance not properly levelled. · Something inside may be vibrating. · Level properly. · Check contents and shelves are properly positioned. E) ALL PRODUCT LIGHTS START FLASHING AND THE ALARM SOUNDS. · Your product has a major fault. · Ring your Technical Oficial Service. 30 Normal noises when functioning 1. Temperature control. May cause clicking sounds when the system is connected or disconnected. 2. [. . . ]