User manual AEG-ELECTROLUX ENL6298KX5

[. . . ] We know you'll enjoy your new fridge-freezer and Thank You for choosing our product. We hope you consider us for future purchases. Welcome Safety Instructions 2 3-4 5-6 7 8 9 - 10 11 - 13 Includes Connecting Ice Maker To Water Supply Installation -- PLEASE READ AND SAVE THESE INSTRUCTIONS Door Removal Instructions Features at a Glance This Use & Care Manual provides specific operating instructions for your model. Use your fridge-freezer only as instructed in this manual. These instructions are not meant to cover every possible condition and situation that may occur. [. . . ] - 100° F IMPORTANT: Resetting The Filter Status Light (some models) After replacing the filter cartridge, it will be necessary to press the Filter Status reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10-15 seconds). Please refer to the complete dispenser operating instructions attached to the inside of the freezer door. On models without a Filter Status reset button, there is a set of Reminder Stickers included in the envelope that the Use & Care Manual came in. Choose a dated sticker that indicates 6 - 9 months (depending on your water quality and usage) from the date of installation. Place the sticker on the front of the filter cup to remind you when it is time to change the filter. 17 Automatic Ice and Water Dispenser PureSource2TM * Ice and Water Front Filter (some models) NOTE: If you purchased a fridge-freezer with a PureSource2TM * Ice and Water front filter, please read the following use and care information. This ice and water filter system filters water to your ice maker and water dispenser. It is located in the upper right front corner of the fresh food compartment. System Startup: Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter. The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section to properly fill the system with water. Changing the Filter: Water conditions vary throughout the world, but changing the water filter every 6 - 9 months normally will ensure the highest possible water quality. When completely in place, the front of the filter cartridge will be flush with the front of the housing. Turn the ice maker's power switch to the On ("I") position. As you are doing this, check for leaks at the filter housing. There will be noticeable spurts and sputters as the system pushes the air out through the system and out the dispenser nozzle. After you have run one glass of water, continue to flush the system for approximately 3 minutes to assure that the purest water possible is stored in the water storage tank. IMPORTANT: Resetting The Filter Status Light (some models) After replacing the filter cartridge, it will be necessary to press the Filter Reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10-15 seconds). Please refer to the complete dispenser operating instructions attached to the inside of the freezer door. 18 Food Storage & Energy Saving Ideas FOOD STORAGE IDEAS Fresh Food Storage · The fresh food compartment should be kept between 1. 1° C and 4. 4° C with an optimum temperature of 2. 8° C. · Avoid overcrowding the fridge-freezer shelves. This reduces the circulation of air around the food and results in uneven cooling. [. . . ] Draw and discard 10 ­ 12 glasses of water to freshen the supply and completely rinse out the tank. Connect unit to cold water line that supplies water to the kitchen tap. For best results, use copper tubing for water connections. CAUSE CORRECTION · Water pressure is extremely low. · · · · · Contact water treatment plant for help. [. . . ]