User manual AEG-ELECTROLUX EOB974C1

[. . . ] We promise that it will provide a superior User Experience delivering Ease-of-Mind. Good luck! 4 electrolux contents Contents Safety instructions Description of the Appliance Before Using for the first time Using the Oven Cleaning and Care What to do if . . . Installation Instructions Disposal Index Service 5 7 13 16 55 70 71 76 77 79 The following symbols are used in this user manual: 1 3 2 Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information operating instructions electrolux 5 Operating Instructions Safety instructions Electrical safety · This appliance must be only connected by a registered electrician. [. . . ] As soon as the oven function is completed, a signal sounds. Press any key to switch off the signal. While the selected oven function with is operating Set+Go, the Key Lock is active (see section Key Lock). Set+Go can be activated or deactivated in the Basic Settings menu. 38 electrolux using the oven Heat+Hold The function Heat+Hold keeps your prepared dish warm for 30 minutes, after the baking or roasting has ended. This is helpful, for example, when your guests are late. Condition for Heat+Hold: · Fixed temperatur is above 80°C · Fixed switch-Duration To switch on Heat+Hold 1. Press key repeatedly until the "Heat+Hold" window appears. The function Heat+Hold is now switched on. As soon as the oven function is completed, a signal sounds and Heat+Hold starts. The oven function runs at 80°C for 30 minutes. As soon as the 30 minutes with Heat+Hold are over, the oven switches itself off. Irrespective of the oven function set Heat+Hold remains active. You can move between the oven functions. Heat+Hold can be activated or deactivated in the Basic Settings menu. using the oven electrolux 39 Time Extension Let the last oven function run again after the time has elapsed. Condition: · All oven functions with Duration or Weight Automatic. You can move between the oven functions. Condition: The oven function to which you move has no fixed cook time. If the Meatprobe is inserted, Duration or End Time is not possible. using the oven electrolux 43 Using residual heat with the Duration and End Time clock functions When the Duration and End Time clock functions are used, the oven switches the heating elements off, when 90% of the time set or calculated has elapsed. The residual heat present is used to continue the cooking process until the time set has elapsed (3 to 20 mins. ). 44 electrolux using the oven Duration bined and End Time com- Duration and End Time can be used simultaneously, if the oven is to be switched on and off automatically at a later time. Press key repeatedly until the "Duration/End Time" window appears. Using the Duration function, set the time required for cooking the dish, e. g. : 1 hour. Using the End Time function, set the time at which the dish is to be ready, e. g. : 14:05. The selected oven function is displayed with the cooking time and switch-off time set for a few seconds. . A message is displayed when the programme starts. using the oven electrolux 45 Key Lock The key lock protects all functions set from accidental changes. Press key repeatedly until the "Key Lock" window appears. Confirm with . The Key Lock does not protect the appliance from being accidentally switched off. After the appliance is switched off, the Key Lock is automatically cancelled. [. . . ] Apply some pressure from above to snap in hook on the other side. 2. From above, insert the door glass at an angle into the door profile at the bottom edge of the door and lower it. 3. Take hold of the door trim (B) at each side, position it on the inside edge of the door and push the door trim (B) onto the upper edge of the door. 68 electrolux cleaning and care On the open side of the door trim (B) there is a guide bar (C). This must be pushed between the outer door panel and the guide rail (D). [. . . ]