User manual AEG-ELECTROLUX EOB975W1

[. . . ] We promise that it will provide a superior User Experience delivering Ease-of-Mind. Good luck! 4 electrolux contents Contents Safety instructions Description of the Appliance Before Using for the first time Using the Oven Cleaning and Care What to do if . . . Installation Instructions Disposal Guarantee/Customer Service Index Service 5 7 13 16 50 60 61 66 67 69 70 The following symbols are used in this user manual: 1 3 2 Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information safety instructions electrolux 5 Safety instructions 5 This appliance conforms with the following EU Directives: 73/23/EEC dated 19. 02. 1973 Low Voltage Directive 89/336/EEC dated 03. 05. 1989 EMC Directive inclusive of Amending Directive 92/31/EEC 93/68/EEC dated 22. 07. 1993 CE Marking Directive Electrical safety This appliance must be only connected by a registered electrician. [. . . ] The value currently set appears in the display. Everyday use of Basic Settings Set+Go The function Set+Go means you can set all settings for an oven function and then start it later. Example application: You prepare a dish in the morning and enter all necessary settings in the oven. Your child comes home at lunchtime, puts the dish in the oven, presses any key and the oven starts with your settings. Condition: Fixed switch-Duration 34 electrolux using the oven To switch on Set+Go 1. Select oven function with desired settings. Press key repeatedly until the "Set+Go" window appears. 3. As soon as the oven function is completed, a signal sounds. Press any key to switch off the signal. While the selected oven function with is operating Set+Go, the Key Lock is active (see section Key Lock). Set+Go can be activated or deactivated in the Basic Settings menu. using the oven electrolux 35 Heat+Hold The function Heat+Hold keeps your prepared dish warm for 30 minutes, after the baking or roasting has ended. This is helpful, for example, when your guests are late. Condition for Heat+Hold: Fixed temperatur is above 80C Fixed switch-Duration To switch on Heat+Hold 1. When the time has counted down to 10%, a short signal sounds. When the time has elapsed, an acoustic signal sounds for 2 minutes and a message is displayed. Press any key to stop the signal (except ). The Minute Minder remains active if you change to another function or the appliance is switched off. using the oven electrolux 39 Duration or End Time Duration For setting how long the oven is to operate. End Time For setting when the oven is to switch itself off again. Press key repeatedly until the "Duration/End Time" window appears. Using or key, set the desired cooking time or switch-off time (max. The settings of the selected oven function are displayed with the cooking time or switch-off time set. When the time has elapsed, an acoustic signal sounds for 2 minutes and a message is displayed. Press any key to stop the signal (except ). 40 electrolux using the oven Irrespective of the oven function set the fixed cook time remains. You can move between the oven functions. Condition: The oven function to which you move has no fixed cook time. If the Meatprobe is inserted, Duration or End Time is not possible. Using residual heat with the Duration and End Time clock functions When the Duration and End Time clock functions are used, the oven switches the heating elements off, when 90% of the time set or calculated has elapsed. [. . . ] cut-outs, fuses (screw fuses are to be taken out of the holder), RCD's and contactors. Anti-shock protection must be provided by the installation. The built-in unit must meet the stability requirements of DIN 68930. Built-in ovens and built-in cooking surfaces are fitted with special connection systems. [. . . ]