User manual AEG-ELECTROLUX EOC6500X

[. . . ] Electric built-in oven INSTRUCTION INSTRUCTION BOOKLET Please read this instruction booklet before using the appliance , Model EOC 6500 / EOC 6500 35692-5201 Important safety information You MUST read these warnings carefully before installing or using the oven. Installation · It is mandatory that all operations required for the installation are carried out by a qualified or competent person, in accordance with existing rules and regulations. It is dangerous to alter the specification in any way. Once you have removed all packaging from the appliance, ensure that it is not damaged and the electric cable is in perfect condition. Otherwise, contact your dealer before proceeding with the installation. [. . . ] 16 Residual Heat Function When a Cooking Duration time is set, the oven will automatically switch off a few minutes before the end of the programmed time, and use the residual heat to finish your dishes without energy consumption. All current settings will be displayed until the Cooking Duration time is over. This function will not operate when the Cooking Duration time is less than 15 minutes. Fig. 15 10 Demo mode This mode is intended to be used in the shops to demonstrate the oven functionality without any power consumption except the oven lamp. To activate this function the appliance should be in stand-by mode. -- Press button and " " for approximately 2 seconds (Fig. An acoustic alarm will sound for a short time. -- Press button and the "id" indication will appear in the display. The thermometer symbol will not flash anymore and "id" indication will be replaced by number digits. Follow the above described procedure to disable the demo mode. Fig. 17 Beep mode You can choose to make The Electronic Control beep each time that a control is touched. To enable this function, the oven must be off. and " " at the same time for about 1. To disable the "Beep" Function: 1. If the oven is on, press control to switch it off. and " " at the same time for about 2. The Electronic Control beeps once. Error code The electronic programmer does a continuous diagnostic check of the system. If some parameters are not correct, the control unit will stop the activated functions and the corresponding error code (letter "F" followed by number digits) will be displayed. For further details, refer to chapter "Something not working" on page 21. 11 Hints and tips Always cook with the oven door closed. The heating elements do not work when the oven door is not completely closed. The oven is supplied with an exclusive system which produces a natural circulation of air and the constant recycling of steam. This system makes it possible to cook in a steamy environment and keep the dishes soft inside and crusty outside. Moreover, the cooking time and energy consumption are reduced to a minimum. [. . . ] " An error code, (for example "F. . xx") appears on the control panel. # Check the instructions for the electronic programmer. # Check that shelves and bakeware are not vibrating in contact with the oven back panel. # Take note of the error code and contact an authorised Service Centre. !The display shows "12. 00". # Set the time of day (see chapter "How the set the time of day"). Technical assistance If after the checks listed in the previous chapter, the appliance still does not work correctly, contact your local Service Centre, specifying the type of malfunctioning, the appliance model (Mod. ), the product number (Prod. No. ) marked on the identification plate. [. . . ]