User manual AEG-ELECTROLUX EOG6000W

[. . . ] Gas built-in oven INSTRUCTION INSTR UCTION BOOKLET Please read this instruction booklet before using the appliance Models EOG 6000 35688-4502 GB Important Safety Information You MUST read these warnings carefully before installing or using the oven. If you need assistance, contact our Customer Care Department on 08705 950950 Installation · This appliance must be installed and serviced by a competent person as stated in the Gas Safety (Installation and Use) Regulations Current Editions and the IEE Wiring Regulations. For appliances installed in the Republic of Ireland please refer to NSAI-Domestic Gas Installations I. S. 813 Current Editions and the ETCI Rules for Electrical Installations. Remove all packaging, both inside and outside the oven, before using the oven. [. . . ] Undo the fixing nut which keep the shelf support in place. When carrying out this operation, keep the shelf support in position with the other hand. Then, disengage the rear hook and take off the shelf support. Then, refit the shelf supports following the procedure in reverse. Please, ensure the retaining nuts are secure when refitting the shelf support. Models in stainless steel or aluminium We recommend to clean the oven door using only a wet sponge and dry it after cleaning with a soft cloth. Never use steel wool, acids or abrasive products as they can damage the oven surface. Clean the oven control panel following the same precautions. 1 2 9 Replacing the Oven Light Disconnect the appliance. If the oven bulb needs replacing, it must comply with the following specifications: - Wattage power: 15 W/25 W, - Voltage: 230 V (50 Hz), - Resistant to temperatures of 300°C, - Connection type: E14. These bulbs are available from your local Service Force Centre. Ensure the oven is disconnected from the electrical supply. Remove the faulty bulb and replace with the new one. Reconnect to the electrical supply. Something Not Working If the appliance is not working correctly, please carry out the following checks, before contacting your local Service Force Centre. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. SYMPTOM The gas oven burner or the gas grill burner do not light SOLUTION Check that the oven is switched on at the wall Check that the power supply has not been interrupted before the cooling fan has had time to cool the oven down Check that there is not a problem with your gas supply Check that you are using the recommended temperature settings and shelf positions. Check that the oven is installed properly. Check that you are using the recommended temperature settings and shelf positions. Check the light bulb, and replace it if necessary (see "Replacing the Oven Light") Refer to the contents of this booklet, especially to the chapter "Using the Gas Oven". Leave dishes inside the oven no longer than 15-20 minutes after the cooking is completed. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. Food is cooking too quickly or too slowly The oven is not cooking evenly The oven light does not work Steam and condensation settle on the food and the oven cavity. If after all these checks, your hob still does not operate correctly, contact your local Electrolux Service Force Centre. Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls. 10 Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Electrolux Service Force Centre by telephoning: 0870 5 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www. serviceforce. co. uk Before calling out an engineer, please ensure you have read the details under the heading "Something Not Working. " When you contact the Service Force Centre you will need to give the following details: 1. Clear and concise details of the fault 4. [. . . ] Remove the bottom plate of the oven ("A") to access the gas oven burner; 2. Undo the two fixing screws ("C") which keep the gas oven burner in place 3. Gently slide the oven gas burner off the injector support ("D") and slowly move it to the left hand side. Check that the burner bush does not slip off the burner mouthpiece, and take care not to cause stress to the spark plug connection wire ("E") and the thermocouple ("F") conductor; 4. [. . . ]