User manual AEG-ELECTROLUX EOG600WL

[. . . ] Model EOG 600 n iot c u d or t nI EOG 600 Introduction This gas oven has been designed and manufactured to all the necessary British Standards. The oven complies with European Council Directive 90/396/EEC. It is important that you understand how to use and care for the oven properly before you use it for the first time. We have written this booklet with your safety in mind. [. . . ] If you use any oven cleaners they must have the Vitreous Enamel Development Council (VEDC) seal of approval. Follow the instructions on the cleaning agent and protect the oven burner with aluminium foil to prevent it becoming blocked. Do not allow the cleaning agents to come into contact with the grill burner. Follow these simple rules to make cleaning easier. Do not overfill dishes or they will boil over. Do not use dishes too high in the oven. If you do they may stick to the grill burner. Cover your roasting tins with foil. This will prevent fat splashing. Use a roasting tin which is just large enough for the meat and potatoes. This will help to reduce fat splashing. Dry any vegetables that you are going to roast. If they are wet there will be more fat splashing. 26 Cleaning between the outer and inner door glass You can remove the glass from the oven door if you need to. To remove the outer glass 1 Open the oven door so you can get at the two cross head screws on the top of the oven door. 2 Loosen these screws using a pozidrive screwdriver. 3 You should hold the door glass securely in place with one hand, whilst removing the screws completely, with the other hand. If you do not do this, the door glass could fall forward. Still holding the door glass, remove the trim from the top of the door. 4 Using both hands, gently tilt the top of the door glass towards you. Lift slightly to disengage the locators at the bottom of the door. 5 Clean the outer and inner glass using hot soapy water and mild abrasives such as 'Jif'. 6 Replace the glass by holding it in both hands and gently placing the locators into the holes of the brackets at the bottom of the door. Push the top of the glass towards the oven door, and make sure the screw location holes line up. Replace the trim on top of the door making sure that it is correctly positioned. You can check this by looking through the air gap on the top of the door and checking that the screw location holes line up. 7 Hold the glass in place with one hand and replace the cross head screws into the location holes, with the other hand. 8 Tighten the screws using a pozidrive screwdriver. 27 Care and cleaning EOG 600 What is wrong and why? EOG 600 What is wrong and why? We strongly recommend that you carry out the following checks on your oven before calling a Service Engineer. Problem The oven or grill will not light. Check l l l Check that the oven is switched on at the wall. Check that the power supply has not been interrupted before the cooling fan has had time to cool the oven down. [. . . ] When the oven burner lights up the sparking should cease. There should be a low gas rate at first to the oven burner which is the flame supervision device (F. S. D. ) by-pass rate. valve and the main gas stream flows to the burner. 2, close the oven door and check that after 10 minutes the flame size has reduced. [. . . ]