User manual AEG-ELECTROLUX EOG9330XN

[. . . ] Model EOG9330 n iot c u d or t nI EOG 9330 Introduction This gas appliance has been designed and manufactured to all the necessary British Standards. The appliance complies with European Council Directive 90/396/EEC. It is important that you understand how to use and care for the appliance properly before you use it for the first time. We have written this booklet with your safety in mind. [. . . ] Wipe the base with a cloth that has been wrung out in hot soapy water. You may use mild abrasives. 24 EOG 9330 Cleaning between the outer and inner door glass You can remove the glass from the oven and grill doors if you need to. You must note the correct position of the trim when you remove the grill door glass. To remove the outer glass 1 Open the door so you can get at the two cross head screws on the top of the door. 2 Loosen these two screws using a pozidrive screwdriver. Please note that the door glass on your product may differ in type and shape from that shown in the diagram. 3 You should hold the door glass securely in place with one hand, whilst removing the screws completely, with the other hand. If you do not do this, the door glass could fall forward. Still holding the door glass, remove the trim from the top of the grill door. Note the correct position of the grill door trim. 4 Using both hands, gently tilt the top of the door glass towards you. Lift it slightly to disengage the locators at the bottom of the door. 5 Clean the outer and inner glass using hot soapy water and mild abrasives such as 'Cif'. 6 Replace the glass by holding it in both hands and gently placing the locators into the holes of the brackets at the bottom of the door. Push the top of the glass towards the door, and make sure the screw location holes line up. Replace the trim on top of the grill door making sure that it is correctly positioned. You can check this by looking through the air gap on the top of the door and checking that the screw location holes line up. 7 Hold the glass in place with one hand and replace the cross head screws into the location holes, with the other hand. 8 Tighten the screws using a pozidrive screwdriver. 25 Care and cleaning Care and cleaning EOG 9330 Cleaning The Door Glass To prevent damaging or weakening the door glass panels avoid the use of the following: Household detergents and bleaches Impregnated pads unsuitable for non-stick saucepans Brillo/Ajax pads or steel wool pads Chemical oven pads or aerosols Rust removers Bath/Sink stain removers If the door glass panel becomes chipped or has deep scratches the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Please contact your local Service Force Centre who will be pleased to advise further. Under no circumstances should the door assembly be detacted from the appliance for cleaning. Plase refer to the cleaning instructions. 26 EOG 9330 What is wrong and why? Maintenance must only be carried out by a competent/qualified person. Do not try to alter/modify the appliance yourself, as this could be dangerous. We recommend that your appliance has an annual gas safety check carried out by our approved service organisation. [. . . ] To set press button (1) and the display will read 0. 00. Release button (1) and press and hold button (2). The display will count up in one minute intervals until the interval to be timed is reached, eg 30 minutes. If necessary press and hold button (1) to achieve the correct time interval. [. . . ]