User manual AEG-ELECTROLUX ER1244T-CH

[. . . ] . Freezing fresh food Storage of frozen food Thawing . . Positioning the door shelves Defrosting . . Maintenance Periodic cleaning . Periods of non-operation Interior light . . Customer service and spare parts. Printed on recycled paper 11 WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. [. . . ] If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. For building into kitchen units follow the special "Building-in" instructions given. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. 1) Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. P P A D B C D C P1 D337 P1 Fig. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 10 PR35 15 USE Control panel (Fig. 12) 21 SN ON SUPER ALARM O 6 5 4 EDC Fig. Thermostat knob (freezer compartment) B. Pilot light Use of the freezer Operation Insert the plug into the wall socket. The pilot light will light up, indicating that the appliance is powered. Turn the thermostat knob, clockwise, beyond the «O» (STOP) position. To stop the appliance, turn the thermostat knob to position «O». Fast freezing To start fast-freezing food, turn the knob towards «S». Pilot light (D) will come on. Warning light Warning light (C) lights up when the temperature inside the freezer compartment has increased to a value which jeopardizes the long-term storage of food in the compartment. [. . . ] 14 Fresh food refrigeration To obtain the best performance: do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it. Useful hints: Meat (all types): wrap in polythene bags and place on the glass shelf above the vegetable drawer. For safety, store in this way only one or two days at the most. [. . . ]