User manual AEG-ELECTROLUX ER1430T

[. . . ] INFO GEBRAUCHSANWEISUNG NOTICE D' U T I L I S A T I O N GEBRUIKSAANWIJZING INSTRUCTION BOOKLET KÜHLSCHRANK REFRIGERATEUR KOELKAST REFRIGERATOR ER 1530 T - ER 1430 T ER 1530 T - ER 1430 T ER 1530 T - ER 1430 T ER 1530 T - ER 1430 T 2222 110-25 This document was created with FrameMaker 4. 0. 4 CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 35 36 36 36 36 37 37 38 38 39 39 39 39 39 40 40 40 41 42 42 42 42 42 Installation . Positioning . Electrical connection . Cleaning the interior . Changing the opening direction of the door . [. . . ] This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +16°C and +32°C (class N) or between +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. For safety reasons, minimum ventilation must be as shown in Fig. 1: Appliance positioned under overhanging kitchen wall units (see Fig. Appliance positioned without overhanging kitchen units (see Fig. Attention: keep ventilation openings clear of obstruction. Two adjustable feet at the cabinet base allow accurate levelling of the appliance. Fig. 1 Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. min. 2 50 cm D584 36 Changing the opening direction of the door Unplug the freezer before performing the following operations: Remove the ventilation grid (C-Fig. Remove the door from the upper pivot (A-Fig. Remove the pivot from the upper hinge (B), then mount it on the opposite side. 2) on the opposite side by using the screws previously removed. To do this, press it in the direction of the arrow. Introduce the plug into the hole left free on the opposite side. 4), reverse the direction of the handle. The unused opening direction is concealed by plastic plugs. Therefore, these plugs are to be mounted on the holes left free. Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabinet. [. . . ] Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer. Ice-cube production (Only for model ER 1430 T) This appliance is equipped with one or more trays for the production of ice-cubes. Fill these trays with water, then put them in the freezer compartment. Do not use metallic instruments to remove the trays from the freezer. 40 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. [. . . ]