User manual AEG-ELECTROLUX ER1620T

[. . . ] ¥ Ice lollies can cause Ôfrost/freezer burnsÕ if consumed straight from the freezer. ¥ It is dangerous to try and alter the specifications or modify this product in any way. ¥ Under no circumstances should you attempt to repair the appliance yourself. Refer to your local Service Centre, and always insist on genuine spare parts. Use and Control Before Use Wait two hours before connecting the appliance to allow the oil to flow back in the compressor. [. . . ] The glass shelf above the vegetable drawers and the bottle shelf should always remain in position, to ensure correct air circulation. Ice cube production The refrigerator is equipped with one or more ice cube trays, which should be filled with drinking water and placed in the special compartment. Defrosting During normal operation, the evaporator in the refrigerator compartment will gradually become covered with frost. This frost is a thermal insulator which inhibits cooling and must therefore be removed, otherwise there will be a significant reduction in cooling efficiency and an increase in electricity consumption. Turn the thermostat knob on position ÒOÓ, making sure that the stopper of the water collector tray is firmly inserted in the water drain hole; 2. Once defrosted, turn the thermostat knob on a medium position to restart the appliance. The water which has collected in the tray placed under the evaporator must be removed. Place a container on the first shelf in the refrigerator directly under the water drain hole of the defrost tray and remove the stopper as shown in the figure. Do not use metal implements to detach the trays. Hints Saving Energy ¥ Pay careful attention to where the cabinet is placed. See the section ÒInstallationÓ. When installed correctly the cabinet will consume less energy. ¥ Try to avoid keeping the doors open for long periods or opening the doors too frequently as warm air will enter the cabinet and cause the compressor to switch on unnecessarily often. ¥ If the ambient temperature is high, the thermostat knob is on the coldest setting (higher numbers) and the appliance is fully loaded, the compressor may run continuously, causing frost or ice to form on the evaporator. If this happens, turn the knob to a warmer setting (lower numbers) to allow a saving in electricity consumption. The cause could be the introduction of large quantities of food and/or frequent opening/closing of the door. Temperature control may cause clicking sounds when the system is connected or disconnected. The injected cooling gas may produce a gurgling sound while passing through the tubes. The motor may cause a humming noise and/or slight bumping. The insulation material used has a tendency to slighly increase noise levels, how ever it allows for much better insulation and a lower energy consumption. It is too warm inside the refrigerator It is too cold inside the refrigerator. The compressor works continuously. Noises Customer service and spare parts If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department and consult the Guarantee card. Selective ordering of replacement parts can save unnecessary travel and costs. For this reason always provide the following appliance information: - Model Name - Model Number (PNC) - Serial Number (S-No. ) This information can be found on the rating plate inside the cabenit on the left hand wall. We recommend that you enter this information here, so that it is handy if needed. 4 Technical specifications The technical data is indicated in the rating plate on the left side inside the appliance. Height 850 mm Width 495 mm Depth 600 mm Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. [. . . ] Attention: keep ventilation openings clear of obstruction. Door reversal Proceed as follows: 1. remove screws (A) which secure the worktop (B) on the back; 2. move the top (B) slightly to release it from the retainers and remove it; B 100 mm A A 10 mm B 10 mm NP008 ¥ Two adjustable feet at the cabinet base allow accurate levelling of the appliance. The climate classification can be found on the rating plate, which is located inside the cabinet on the left hand wall. [. . . ]