User manual AEG-ELECTROLUX ER1622T

[. . . ] INFO INSTRUCTION BOOKLET REFRIGERATOR ER 1622 T 2222627-58 CONTENTS Instructions for the User Important Safety Instructions Description of the Appliance Operation Before use Setting the temperature Fresh food refrigeration The door shelves Instructions for the Installer 3 4 5 5 5 5 5 Technical Specifications Installation Positioning Door reversal 9 10 10 11 Electrical Connection 12 Health and Safety Guidelines Defrosting Normal Operating Sounds 6 6 6 Maintenance and Cleaning Internal cleaning External cleaning Changing the light bulb When the appliance is not in use 7 7 7 7 7 Something Not Working?Service and Spare Parts 8 9 2 IMPORTANT SAFETY INSTRUCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance as your safety is of paramount importance. Prior to Installation s General Safety s Check the appliance for transport damage. Under no circumstance should a damaged appliance be installed. [. . . ] It then took 11 hours to get down to 7°C in the refrigerator. s Keep the refrigerator door closed as much as possible. s Do not push food together too much, try to allow air to circulate around each item. s Cool cooked food as quickly as possible but do NOT place in the refrigerator until cool. (Leave food in a cool place in order that it can then be placed in the refrigerator as soon as possible). s Do NOT mix raw and cooked meat, they must be in separate containers. Take care not to let the meat juices drip onto other food. If the meat does drip, remove everything and clean thoroughly. s s s s s s s Do not store food uncovered. Remove suspect food from your refrigerator and clean the interior (see "Maintenance and Cleaning"). Never allow spillages to dry and harden. Store eggs in the egg rack provided in the refrigerator door. Regularly check the refrigerator door seal to ensure that it is clean and free from debris. Always wash your hands with soapy water and dry them with a clean towel before handling food. Keep work surfaces clean and avoid cross contamination by not using the same work surface or knife, without washing them thoroughly in between. DEFROSTING The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via a water discharge hole, into a tray located at the back of the appliance above the compressor, where it evaporates. Important To avoid defrost water overflowing into the fridge, periodically clean the water discharge hole in the centre of the V shaped drip collector at the back of the refrigerator compartment behind the salad drawer. Use the special cleaner provided which you will find already inserted into the discharge hole. D037 Normal Operating Sounds You may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear, to the cooling plate. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or 6 pulsating noise from the compressor. A thermostat controls the compressor, and you will hear a faint `click' when the thermostat cuts in and out. MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Warning This appliance contains hydrocarbons in its cooling unit, maintenance and recharging must therefore only be carried out by authorised technicians. When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the door ajar to prevent unpleasant smells. Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0. 5 litre of water). NEVER USE DETERGENTS, ABRASIVE POWDERS, HIGHLY PERFUMED CLEANING PRODUCTS OR WAX POLISHES, TO CLEAN THE INTERIOR AS THESE WILL DAMAGE THE SURFACE AND LEAVE A STRONG SMELL. Clean the drain hole of the water trough at regular intervals and make sure that the drain hole is never obstructed, so that the defrost water may flow freely. External cleaning Wash the outer cabinet with warm soapy water. [. . . ] When the bottom hinge is screwed in, a certain amount of force is exerted on the screws. It is therefore advisable to lubricate the screw tips before starting this operation. Important After completion of the door reversal operation, verify that the door gasket is sealing onto the cabinet. If the ambient temperature is cold (i. e. [. . . ]