User manual AEG-ELECTROLUX ER1721U

[. . . ] This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance should be serviced by an authorized Service Centre, and only genuine spare parts should be used. [. . . ] If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. For building into kitchen units follow the special "Building-in" instructions given. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 11 Location Fig. 4 600 547 550 820-870 This appliance is designed to be built-in to a space having the dimensions given in Fig. 1. D510 59 6 D506 100-170 Take the hinge rem o v e d f ro m t h e upper part of the appliance on the opposite side (see Fig. 4), and, using t h e s c re w s r e m o v e d f ro m t h e lower part, fix it to the base of the appliance itself. Fig. 2 The height of the appliance can be altered if required by means of adjustable feet situated at its base (Fig. 2). Remove and refit the other hinge on the upper part of the appliance on the opposite side. Fix the two front screws into the upper and lower hinges (Fig. Finally, check the alignment of the door and make sure it closes properly. After having reversed the opening direction of the door, discard the original plastic insert removed and fit the insert supplied with the appliance on the opposite side. D507 Fitting a decorative door panel Important: The components needed to fit the decorative panel have been pre-fitted on the appliance. The brackets are secured to the panel by means of the 7 Ø 3. 5x13 screws supplied. Before starting to fit the panel, remove the large top bracket by unscrewing the screws and adjusting pins pre-fitted on the appliance door. The small bottom bracket need not be removed. Fig. 5 Door reversibility Remove the two screws which fix the upper hinge to the door. Fig. 3 Carefully lean the appliance on its back and remove the plastic insert (Fig. 3). A = = D447 Remove the two screws which fix the lower hinge to the door. [. . . ] Milk bottles: these should have a cap and should be stored in the bottle rack on the door. D037 15 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Interior light The light inside the refrigerator compartment is easy to get at through the opening in the light holder. If the light does not come on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb. The rating is shown on the light bulb cover. Fig. [. . . ]