User manual AEG-ELECTROLUX ER2344B

[. . . ] The refrigerant isobutane (R600a) is contained within the refrigerant circuit of the appliance, a natural gas with a high level of environmental compatibility, which is nevertheless flammable. During transportation and installation of the appliance, be certain that none of the components of the refrigerant circuit become damaged. If the refrigerant circuit should become damaged: ­ avoid open flames and sources of ignition ­ thoroughly ventilate the room in which the appliance is situated · It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock. [. . . ] Report possible damages immediately to the place you bought it. It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in the compressor. Adequate air circulation should be around the appliance, lacking this leads to overheating. to achieve sufficient ventilation follow the instructions relevant to installation. Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn. The appliance must not be located close to radiators or cookers. Make sure that the mains plug is accessible after the installation of the appliance. Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician or competent person. ⷠThis product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. You may hear a faint gurgling and a bubbling sound when the refrigerant is pumped through the coils or tubing. When the compressor is on, the refrigerant is being pumped around and you will hear a whirring sound and a pulsating noise from the compressor. The thermic dilatation might cause a sudden cracking noise. When the compressor switches on or switches off, you will hear a faint "click" of the temperature regulator. Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time Electrolux 13 the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole. ⷠPut insulating material around the drawers, e. [. . . ] Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet. It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. This can be achieved by two adjustable feet at the bottom in front. Electrolux 15 Removing the shelf holders Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. [. . . ]