User manual AEG-ELECTROLUX ER2824I

[. . . ] INFO I S T R U Z I O N I P E R L' I N S T A L L A Z I O N E E L'USO INSTALLATION AND INSTRUCTION MANUAL INSTALLATIONS- UND GEBRAUCHSANWEISUNG FRIGORIFERO-CONGELATORE FRIDGE-FREEZER KÜHL-GEFRIERSCHRANK ER 2824 I ER 2824 I ER 2824 I 2222 014-43 This document was created with FrameMaker 4. 0. 4 CONTENTS Warnings . page 11 12 12 12 12 12 12 15 15 15 15 15 16 16 16 16 16 17 18 19 19 19 19 19 Installation . Cleaning the interior . Building-in instructions . . Starting-up - Temperature Regulation . [. . . ] Remove (A) and refit it on the opposite side. Refit the door and (P) on the left side. Remove (P1) from the right side. 12 Housing dimensions Height Depth Width 1580 mm 550 mm 560 mm Fig. 5 For appropriate venting, follow indications in Fig. cm 2 200 D D316 C Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. Fig. 3 A Push appliance into the housing until stop strip (A) touches the kitchen unit. Press in the joint covers between the appliance and the kitchen unit. 5 4 32 1 0 D320 Fig. 4 A D265 If after having carried out the previously described operation there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Apply covers (B) on joint cover lugs and into hinge holes. B D013 13 Fig. 11 E 20m m D285 Position the runners (E) at the top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 9 G H G D317 In case of side fixing of the appliance, it will be sufficient to loosen the screws fixing the brackets (F) and to position them as shown in F i g . F i n a l l y, mount the cover (G). 8mm PR34 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 10 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit PR35 door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. 14 OPERATION Starting-up - Temperature Regulation Turn the thermostat knob clockwise to the required setting (beyond position «O»); the recommended setting is between 2 and 4. Temperature is regulated automatically and can be increased by turning the knob to lower numbers, or decreased by turning it to higher numbers. However the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: room temperature; how often the door is opened; the quantity of food stored in the refrigerator; location of appliance. [. . . ] «Wine Cellar» (d) This is for storing wine, fruit, unripe tomatoes, potatoes, lemons, sausages, soft drinks, hard cheese, canned food, etc. and for vegetables such as cabbage, spinach, chicory, cauliflower, broccoli. Fig. 14 a Freezer b b b c 543210 Refrigerator d Wine cellar 5 4 3 2 F 1 0 D641 17 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough (Fig. [. . . ]