User manual AEG-ELECTROLUX ER3112B

[. . . ] Ensure that you understand them all before installing or using the appliance. If you are unsure about any of the meanings or warnings contact the Customer Care Department. · Do not keep carbonised drinks or bottles in the For the User freezer compartment. The glass bottles may · The cabinet is intended for keeping foodstuff in a break. [. . . ] Certain shelves must be lifted up by the rear edge to enable them to be removed. The lower door compartment and the glass shelf above the vegetable drawer must not be moved. They are required for proper air circulation inside the cabinet. Shelves with a raised edge should be placed with the raised edge facing the rear wall of the cabinet, and thus prevent food products from touching the cooling plate. The vegetable drawer has a removable ventilation edging to increase the circulation of air and reduce the risk of condensation. The vegetable drawer has two moveable partitions with five different choices in order to separate different vegetables. Electrolux 818 38 31-00/0 5 Hints and Tips Saving energy · Pay careful attention to where the cabinet is placed. See the section "Installation". When installed correctly, the cabinet will consume less energy. Try to avoid keeping the door open for long periods, or opening the door too frequently as warm air will enter the cabinet, and cause the compressor to switch on unnecessarily often. Ensure there are no obstructions preventing the door from closing properly. This will ensure safer defrosting of foods and reduce the work of the refrigeration unit It is advisable to periodically clean the refrigeration system at the back of the appliance with a duster or vacuum cleaner. Once or twice a year dust the condenser (black grille) and the compressor at the back of the appliance, with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. Defrosting the fridge The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented by: · not putting warm foodstuff inside the cabinet. · avoiding frequently opening the door or keeping it open too long. · do not place foodstuffs directly against the cold cooling plate. When moving the cabinet, lift it by the front edge to avoid scratching the floor. To change the light bulb The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet. Cut the packaging around the bulb socket. Keep the packaging on to hold the bulb when setting it into the socket. Do not touch the bulb with your bare fingers. Halogen light bulbs are sensitive to grease from the skin. Use a clear halogen light bulb. G4 UV-blocked 20W/12V Low pressure When the appliance is not in use Disconnect the appliance from electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. [. . . ] · there is a risk of electric shock or fire. To obtain the best performance from the cabinet, ensure : · the cabinet is placed in a dry, cool place and is not exposed to direct sunlight. · the cabinet is not placed close to a source of heat, e. g. The cabinet should not lean against any wall. [. . . ]