User manual AEG-ELECTROLUX ER3121D

[. . . ] This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance should be serviced by an authorized Service Centre, and only genuine spare parts should be used. [. . . ] A 6% fluctuation above or below rated voltage is acceptable. For operation using different voltages you should use an autotransformer of suitable capacity. The appliance's plug and the wall socket are fully compatible, without any need to use adaptors, multiple plugs, etc. If this is not the case, the wall socket should be replaced to make it compatible. The appliance MUST be connected to an efficient earth or ground tap. The supply lead plug in fact incorporates a special earth or ground contact for this purpose. If by any chance the sockets of your domestic wiring system are not earthed, the appliance must be connected to a separate earth or ground wire by a qualified electrician, in accordance with existing safety regulations. The manufacturer declines to accept any liability if this accident-prevention procedure is not followed. 87/ 308 of 2. 6. 87 relative to radio interference suppression. This appliance complies with the following A B D042 Rear spacers In the plastic envelope containing the Operation Instructions are also included two wall spacers to be fitted into the special openings provided on the back of the appliance. Push-fit the spacers into the openings, making sure that arrow (A) is positioned as per Fig. 2 and then turn the spacers through 45° until they lock in (arrow in vertical position). E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the appliance's interior Before using the appliance for the first time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then drv thoroughly. Do not use detergents or abrasive powders as these will damage the finish. 11 Door reversibility Unplug the appliance before carrying out any operation. Remove the ventilation grid (2); to do this, loose the frontal screws and pull it downward sliding it from the central stop runners; remove the lower hinge (1); remove the pin (C) from the opening (A) and refit it in the opening (B); remove the door stop hinge (D) and refit it on the opposite side; slide the lower door out of the centre hinge; remove the centre hinge (4) and the upper hinge (3) and refit them on the opposite side; refit the lower door and hinge (1) on the opposite side; refit the ventilation grid upside-down; take off the handle covers (Fig. 4), remove handles and refit them on the opposite side. D158 Fig. 3 3 5 4 6 D C A 1 B 2 Fig. 4 B0646 12 USE Operation - Temperature regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found on the upper right side of the inner liner, clockwise, beyond the «O» position (STOP), to start the appliance. Temperature adjustment is obtained by turning the thermostat knob to the required setting. A medium setting is generally the most suitable. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on a number of factors, such as: room temperature, how often the doors are opened, the quantity of food stored in the refrigerator and the location of the appliance. [. . . ] If the light does not go on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb. The rating is shown on the light bulb cover. Fig. 9 D025 SERVICING AND SPARE PARTS If the appliance is not working If the appliance is not functioning properly check that: the plug is firmly inserted in the wall socket and the mains power switch is on; there is no power failure; the thermostat knob is in the right position. [. . . ]