User manual AEG-ELECTROLUX ER3124I

[. . . ] INFO INSTALLATIONS- UND GEBRAUCHSANWEISUNG I N S T R U C T I O N S P O U R L' I N S T A L L A T I O N E T L' E M P L O I INSTALLATION AND INSTRUCTION MANUAL I S T R U Z I O N I P E R L' I N S T A L L A Z I O N E E L'USO ER 3124 I REFRIGERATEUR-CONGELATEUR ER 3124 I FRIDGE-FREEZER ER 3124 I FRIGORIFERO-CONGELATORE ER 3124 I KÜHL- GEFRIERKOMBINATION 2222 001-72 This document was created with FrameMaker 4. 0. 4 CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 23 24 24 24 24 24 25 27 27 27 27 27 27 27 28 28 28 28 29 29 29 29 29 29 30 31 31 31 31 31 Installation . Positioning . Electrical connection . . Control panel Use of the freezer . [. . . ] Do not use detergents or abrasive powders, as these will damage the finish. Door reversibility (Fig. 1) P P A D B C D C P1 D337 P1 Fig. 1 Right opening Remove the pins (P) and (P1). Left opening Remove (P) from both sides and the door. Remove (A) from the left side and (B-C-D) from the right side. Refit (B-C-D) on the left side and (A) on the right side. Refit the door and (P) on the left side. Remove (P1) from the right side. 24 Building-in instructions Housing dimensions Height Depth Width 1780 mm 550 mm 560 mm Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grill (C) and hinge cover (D) into position. Fig. 5 For safety reasons, minimum ventilation must be as shown in Fig. 2: Attention: keep ventilation openings clear of obstruction. 50 mm min. cm2 200 C D596 Press in the joint covers between the appliance and the kitchen furniture. Fig. 6 D526 Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. 3 A D098 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 D023 If after having carried out the operation described in section 3 there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 4 B A D096 D265 25 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 8 In case of side fixing of the appliance, it will be sufficient to loose the screws fixing the bracket (E) and to position it as shown in Fig. 11 H E 20m m D597 E D094 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. [. . . ] Cooked foods, cold dishes, etc. . : these should be covered and may be placed on any shelf. Fruit and vegetables: these should be thoroughly cleaned and placed in the special drawer(s) provided. D450 29 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. [. . . ]