User manual AEG-ELECTROLUX ER3319C

[. . . ] If you are unsure about any of the meanings or warnings contact the Customer Care Department. the refrigerating system on the back of and inside For the User the cabinet. If the refrigerating system is · The refrigerator is intended for the storage of punctured, the cabinet will be damaged and foodstuffs and the production of cold water, with foodstuff inside may spoil. or without carbon dioxide, for normal household · Do not keep carbonised drinks or bottles in the use in accordance with these instructions. [. . . ] They are required for proper air circulation inside the cabinet. Shelves with a raised edge should be placed with the raised edge facing the rear wall of the cabinet. The vegetable drawer has a ventilation edging to increase the circulation of air and reduce the risk of condensation. The vegetable drawer has two moveable partitions with five different choices in order to separate different vegetables. Bottle- and can holder The side of the bottle and can holder is moveable to enable a more flexible placement of cans and bottles in front of the grid. To allow the holder to be moved easier, when moving sideways, press the shelf backwards. During chilling of cans or bottles the article should be centrally placed in front of the grid to obtain the best chilling effect. The bottle support can be pulled out when chilling larger bottles. Follow the advice in the section "Saving energy" The door gasket and coolant used in this cabinet will not harm the ozone layer. All parts in the packaging can be recycled. The cabinet has been designed for easy dismantling and subsequent recycling. · · · · · · Food Storage · To obtain the best results from your appliance, neither hot foods nor liquids which may evaporate, should be placed in the larder Maintenance and Cleaning Removing the ventilation grille The ventilation grille can be removed, e. g. Make sure the door is open when removing the ventilation grille. The replacement gas cylinder is obtained through your local dealer. Defrosting the fridge The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented by: · not putting warm foodstuff inside the cabinet. · avoiding frequently opening the door or keeping it open too long. To change the light bulb The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet. Cut the packaging around the bulb socket. Keep the packaging on to hold the bulb when setting it into the socket. Do not touch the bulb with your bare fingers. Halogen light bulbs are sensitive to grease from the skin. Use a clear halogen light bulb. G4 UV-blocked 20W/12V Low pressure Change of carbon filter To maintain the best performance the carbon filter should be changed once a year with normal usage. New carbon filters can be purchased from your local dealer. The filter is placed behind the grill and can be reached by opening the cover. [. . . ] · In the event of damage to the appliance's main cable, only an authorised service company recommended by the manufacturer or a similarly qualified person may adjust it in order to avoid shock hazard for the user. 2 3 14 Electrolux 818 38 21-01/9 Installing the cabinet When two appliances are placed beside each other, the distances enclosed in the plastic wrapping should be glued between the appliances. To obtain the best performance from the cabinet, ensure : · the cabinet is placed in a dry, cool place and is not exposed to direct sunlight. · the cabinet is not placed close to a source of heat, e. g. The cabinet should not lean against any wall. [. . . ]