User manual AEG-ELECTROLUX ER3604D

[. . . ] Ensure that you understand them all before installing or using the appliance. If you are unsure about any of the meanings or warnings contact the Customer Care Department. The edges and projecting For the User parts of the cabinet may be sharp. Be careful · The cabinet is intended for keeping foodstuff in a when moving the cabinet and always use gloves. [. . . ] It is required to assure proper air circulation. Cold accumulator The cold accumulator will keep the food cold for longer after a power failure. The cold accumulator will be most effective when placed at the front of the fast-freezing tray. When freezing large amounts of food/provisions, the accumulator moves to the tray/space nearest to the lower freezing shelf. When defrosting: Place the cold accumulator on top of the frozen food to keep it cold. Freezer tray Use the freezer tray to freeze berries and vegetables. After about 4 hours the food will be thoroughly frozen and can then be packaged normally. Food that is frozen in this way will not stick together, enabling you to use only the amount required. Release the ice cubes by twisting the ice tray. If ice cubes are kept for a long time, they will dry out and the taste is affected. Thus, throw away old ice cubes and prepare new ones when needed. 7 Electrolux 818 17 44-00/7 Hints and Tips Saving energy · Pay careful attention to where the cabinet is placed. Carefully scrape off the ice when it starts to thaw. Do not use sharp objects as these may damage the interior. When all the ice has melted, clean and wipe the cabinet dry, then push the drain spout back in place. Switch on the cabinet and replace the frozen foodstuff. Never use a hair drier or other heating appliances to speed up defrosting. Excessive heat may damage the plastic interior, and humidity could enter the electric appliance making it live. Electrolux 818 17 44-00/7 9 Defrosting the fridge The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented by: · not putting warm foodstuff inside the cabinet. · avoiding frequently opening the door or keeping it open too long. · do not place foodstuffs directly against the cold cooling plate. To Change the Light Bulb The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet. Cut the packaging around the bulb socket. [. . . ] The ventilation space above the cabinet must be at least 200 cm@. The ventilation space can either be a) directly above the cabinet, or b) behind and above the top cupboard. In this case, the space behind the cupboard must be at least 50 mm deep. Cabinet is placed at a location whose ambient temperature corresponds to the climate classification*, for which the appliance is designed. [. . . ]