User manual AEG-ELECTROLUX ER6348TYE

[. . . ] Under no circumstance should a damaged appliance be installed. In the event of damage please contact your retailer. s Installation s s s s s s This appliance is heavy. It is dangerous to alter the specifications or attempt to modify this product in any way. Ensure that the appliance does not stand on the electrical supply cable. [. . . ] Keep the refrigerator door closed as much as possible. Do not push food together too much, try to allow air to circulate around each item. Cool cooked food as quickly as possible but do NOT place in the refrigerator until cool. (Leave food in a cool place in order that it can then be placed in the refrigerator as soon as possible). Do NOT mix raw and cooked meat, they must be in separate containers. Take care not to let the meat juices drip onto other food. If the meat does drip, remove everything and clean thoroughly. The best way to defrost food is to put it in the refrigerator to thaw slowly. Ensure that food placed in the freezer compartment is dated and labelled and used in date order to ensure that food is consumed at its best. It is important that food is used before its "best before" date. The foods to be frozen must be fresh and of the best quality. Keep clean to guarantee good ventilation and good working order of the appliance. An accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. The structure of the appliance permits to clean the rear zone close to the wall, using a vacuum cleaner. Remove the plinth (1), then the ventilation grid (2); 2. Carefully pull the air deflector out (3), checking that there is no water left from the defrosting. 3 2 1 S. I. 013 When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the door ajar to prevent unpleasant smells. 9 SOMETHING NOT WORKING? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom No power to appliance Solution - Check there is power at the socket. - Check there is not a power cut by checking the household lights. - Ensure that the bulb is correctly fitted. - Check the door light switch is not jammed. - Check the ambient temperature is within the appliances operating limits of 10°C to 38°C. - Check the thermostat control knob is turned to the correct setting relative to ambient conditions. [. . . ] FUSE BROWN BUILDING-IN INSTRUCTIONS Before carrying out any work, remove the plug from the power socket. Inner door reversal 1. Using a screwdriver release bracket (1) by pressing on the internal spring (Fig. ) and withdraw it from its seat together with the door; 2. remove plug (2) and fit it in the hole left open on the opposite side; 3. turn the door through 180°, remove the bracket (1) and refit it on the opposite side. [. . . ]