User manual AEG-ELECTROLUX ER6422T

[. . . ] Never use metal objects for cleaning your appliance as it may get damaged. Installation s Service / Repair s s s Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance should be serviced by an authorised Service Centre, and only genuine spare parts should be used. Under no circumstances should you attempt to repair the appliance yourself. [. . . ] Meat and fish should therefore be stored (wrapped in aluminium foil or cling film) on the top shelf. Cooked food (cover well to avoid it drying out) can be placed on any shelf. Fruit and vegetables should be placed in the drawer provided. Butter and eggs and also bottles should be placed in the door compartments. For best refrigeration results, it is important to follow the rules below: s do not cover the shelves with paper, aluminium foil or protective plastic sheeting; s arrange the food so that air can circuiate freely around it; s cover food, particularly if it has a strong smell; s do not open the door too often; s do not put warm food in the refrigerator, leave to cool at ambient temperature before placing inside. Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: room temperature; how often the door is opened; the quantity of food stored; location of appliance. A medium setting is generally the most suitable. To stop operation, simply turn the thermostat knob to position «O». 12 Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. D040 Positioning the door shelf To permit storage of food packages of various sizes, central the door shelf can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes off, then reposition as required. Ice cube production The refrigerator is equipped with one or more ice cube trays, which should be filled with drinking water and placed in the special compartment. Do not use metal implements to detach the trays. Defrosting During normal operation, the evaporator in the refrigerator compartment will gradually become covered with frost. This frost is a thermal insulator which inhibits cooling and must therefore be removed, otherwise there will be a significant reduction in cooling efficiency and an increase in electricity consumption. Press the button in the centre of the thermostat knob; 2. Once defrosted, the refrigerator will start up again automatically but the water which has collected in the basin placed under the evaporator must be removed. 13 Maintenance Unplug the appliance before carrying out any maintenance operation. The light bulb The opening on the diffuser gives access to the light bulb. If the light does not come on when the door is opened, check that the bulb is screwed in properly; replace the bulb if the fault persists. The rating is shown on the light bulb cover. Periodic clearing Clean the inside with warm water and bicarbonate of soda. Clean the outside with a silicone wax spray. [. . . ] Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. 15 Door reversibility The appliance must be unplugged before starting work. To reverse the opening direction of the door, proceed as follows: 1. [. . . ]